Cisco 3750 - Catalyst EMI Switch Başlangıç Kılavuzu - Sayfa 13

Anahtar Cisco 3750 - Catalyst EMI Switch için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco 3750 - Catalyst EMI Switch 27 sayfaları. Catalyst 3750 series switches
Ayrıca Cisco 3750 - Catalyst EMI Switch için: Veri Sayfası (18 sayfalar), Kurulum Manüelleri (47 sayfalar), SSS (10 sayfalar), Ürün Bülteni (5 sayfalar), Ürün Destek Bülteni (6 sayfalar), Ürüne Genel Bakış (25 sayfalar), Açıklama (1 sayfalar), Veri Sayfası (23 sayfalar), Ürün Destek Bülteni (6 sayfalar), Veri Sayfası (23 sayfalar), Başlangıç Kılavuzu (33 sayfalar)

Rack-Mounting

This section covers basic 19-inch rack-mounting and switch port connections. As an example, all the

illustrations show the Catalyst 3750G-48TS switch. You can install and connect other Catalyst 3750

switches as shown in these illustrations. For alternate mounting procedures, such as installing the

switch in a 24-inch rack or on a wall, and for additional cabling information, see the Catalyst 3750

Switch Hardware Installation Guide on Cisco.com.

You need to supply a number-2 Phillips screwdriver to rack-mount the switch.

When determining where to install the switch, verify that these guidelines are met:

• Airflow around the switch and through the

vents is unrestricted.

• Temperature around the switch does not

exceed 113°F (45°C).

• Humidity around the switch does not exceed

85 percent.

• Altitude at the installation site is not greater

than 10,000 feet.

• Clearance to the switch front and rear panels

meets these conditions:

Front-panel LEDs can be easily read.

–

Access to ports is sufficient for

–

unrestricted cabling.

AC power cord can reach from the

–

AC power outlet to the connector on the

switch rear panel.

Access to the rear of the rack is sufficient

–

for connecting StackWise cables to

stacked switches.

• Cabling is away from sources of electrical

noise, such as radios, power lines, and

fluorescent lighting fixtures.

• For 10/100 ports and 10/100/1000 ports, the

cable length from a switch to an attached

device cannot exceed 328 feet (100 meters).

• For cable lengths for small form-factor

pluggable (SFP) modules, see the

documentation that shipped with the module.

• For cable lengths for XENPAK modules, see

the documentation that shipped with the

module.