Cisco 3750 - Catalyst EMI Switch Başlangıç Kılavuzu - Sayfa 4

Anahtar Cisco 3750 - Catalyst EMI Switch için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco 3750 - Catalyst EMI Switch 27 sayfaları. Catalyst 3750 series switches
Ayrıca Cisco 3750 - Catalyst EMI Switch için: Veri Sayfası (18 sayfalar), Kurulum Manüelleri (47 sayfalar), SSS (10 sayfalar), Ürün Bülteni (5 sayfalar), Ürün Destek Bülteni (6 sayfalar), Ürüne Genel Bakış (25 sayfalar), Açıklama (1 sayfalar), Veri Sayfası (23 sayfalar), Ürün Destek Bülteni (6 sayfalar), Veri Sayfası (23 sayfalar), Başlangıç Kılavuzu (33 sayfalar)

Sayfayı Yazdır

Cisco 3750 - Catalyst EMI Switch Başlangıç Kılavuzu

Running Express Setup

When you first set up the switch, you should use Express Setup to enter the initial IP information. This

enables the switch to connect to local routers and the Internet. You can then access the switch through

the IP address for further configuration.

To run Express Setup:

Make sure that nothing is connected to the switch.

Step 1

During Express Setup, the switch acts as a DHCP server. If your PC has a static IP address,

change your PC settings before you begin to temporarily use DHCP.

Power the switch by connecting the supplied AC power cord to the switch power

Step 2

connector and to a grounded AC outlet.

When the switch powers on, it begins the power-on self-test (POST). During POST, the

Step 3

LEDs blink while tests verify that the switch functions properly.

Wait for the switch to complete POST, which can take several minutes.

Verify that POST has completed by confirming that the SYST LED remains green. If the

Step 4

switch fails POST, the SYST LED turns amber.

POST errors are usually fatal. Contact your Cisco technical support representative if your

switch fails POST.

Press and hold the Mode button for

Step 5

3 seconds. When all of the LEDs left

of the Mode button turn green,

release the Mode button.

If the LEDs left of the Mode button

begin to blink after you press the

button, release it. Blinking LEDs

mean that the switch has already

been configured and cannot go into

Express Setup mode. For more

information, see the "Resetting the

Switch" section.

Verify that the switch is in Express Setup mode by confirming that all LEDs left of the

Step 6

Mode button are green. (On some models, the RPS and PoE LEDs remain off.)

SY ST

R PS

ST AT

D U PL X

SP EE D

Po E

M O DE

Mode button

15 X

16 X