Cisco 6260 Manuel - Sayfa 5

Anahtar Cisco 6260 için çevrimiçi göz atın veya pdf Manuel indirin. Cisco 6260 24 sayfaları. Quad-port flexi atu-c to octal-port dmt atu-c line card conversion procedures
Ayrıca Cisco 6260 için: Hızlı Referans Kılavuzu (38 sayfalar)

Sayfayı Yazdır

The DS3 ports are not intended to be connected to cables that run outside the building where it is

Warning

installed. For any connections outside the building, the DS3 ports must be connected to a network

termination unit (NTU). NTU devices should comply with appropriate national safety standards

such as UL 1950, CSA 950, EN 60950, IEC 950, and AS 3260.

Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed

Warning

circuitry could constitute an energy hazard.

Warning

Only trained and qualified personnel should be allowed to install, replace, or service

this equipment.

Warning

Do not work on the system or connect or disconnect cables during periods of lightning activity.

To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.

Warning

The power supply circuitry for the equipment can constitute an energy hazard. Before you install

Warning

or replace the equipment, remove all jewelry (including rings, necklaces, and watches). Metal

objects can come into contact with exposed power supply wiring or circuitry inside the DSLAM

equipment. This could cause the metal objects to heat up and cause serious burns or weld the

metal object to the equipment.

Ultimate disposal of this product should be handled according to all national laws

Warning

and regulations.

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not

Warning

directly touch the backplane with your hand or any metal tool, or you could shock yourself.

Warning

This equipment is to be installed and maintained by service personnel only as defined by AS/NZS

3260 Clause 1.2.14.3 Service Personnel.

Warning

Blank faceplates and cover panels serve three important functions: they prevent exposure to

hazardous voltages and currents inside the chassis; they contain electromagnetic interference

(EMI) that might disrupt other equipment; and they direct the flow of cooling air through the

chassis. Do not operate the system unless all cards, faceplates, front covers, and rear covers are

in place.

OL-0991-01

Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures

General Safety Precautions and Maintenance Guidelines