Cisco 7507 Hızlı Başlangıç Kılavuzu - Sayfa 4
Anahtar Cisco 7507 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco 7507 44 sayfaları. Air filter and chassis blower replacement
Ayrıca Cisco 7507 için: Kurulum Talimatları Kılavuzu (39 sayfalar), Veri Sayfası (11 sayfalar), Değiştirme Talimatları Kılavuzu (21 sayfalar)
Sayfayı Yazdır
Install the Hardware
Prepare to Install the Router
Note
For detailed hardware installation
instructions and safety guidelines, refer to the Cisco
7500 Series Router Installation and Configuration
Guide, Site Preparation and Safety Guide, and the
Cisco 7500 Regulatory Compliance and Safety
Guide.
Warning
personnel should install, replace, or service
this equipment.
Step 1
Lift the router safely out of the packing
container.
Step 2
Ensure the power service at the site is
suitable for the router you are installing.
2
Step 3
Check the packing slip to ensure that all
the proper components are present.
Step 4
Confirm that you have the required tools
and parts:
For rack-mounting (optional):
•
Two mounting brackets (left and right are
identical), each with an attached spanner bar
•
Two chassis ears (each holds two captive
grommets)
•
Fasteners
•
Ten 10-32 x 5/8-inch LG Phillips pan-head
screws with integral washers
•
Four M4 x 10-mm LG Phillips, flat-head screws
•
Number 2 Phillips screwdriver
Only trained and qualified
•
One 7/16-inch open-end (or adjustable) wrench
if you will remove the chassis feet
•
Tape measure or level (both optional)
•
Ohmmeter if your installation requires the
chassis be electrically isolated from the rack
•
Number 2 Phillips or 1/4-inch flat-blade
screwdriver for the power supply (Due to
product improvements, some power supplies use
slotted screws, and others use Phillips screws.)
•
Cable ties may be needed to temporarily anchor
the cables when installing the power supplies.
For DC-Input Power Supply:
•
Twin-lead, 10-AWG cable terminal block
connection
•
Single 10-AWG wire for the ground connection
•
Number 1 Phillips or 3/16-inch flat-blade
screwdriver
For interface modules (optional):
•
Number 1 Phillips or 3/16-inch flat-blade
screwdriver