Cisco 9124 - mds multilayer fabric switch Yayın Notu - Sayfa 18

Anahtar Cisco 9124 - mds multilayer fabric switch için çevrimiçi göz atın veya pdf Yayın Notu indirin. Cisco 9124 - mds multilayer fabric switch 22 sayfaları. Mds 9000 series
Ayrıca Cisco 9124 - mds multilayer fabric switch için: Teknik Özellikler (2 sayfalar), Veri Sayfası (9 sayfalar), Teknik Özellikler (3 sayfalar), Yapılandırma Kılavuzu (49 sayfalar), Yayın Notu (48 sayfalar), Yayın Notu (44 sayfalar), Yayın Notu (36 sayfalar), Yayın Notu (3 sayfalar), Yayın Notu (40 sayfalar), Manuel (16 sayfalar), Donanım Kurulum Kılavuzu (36 sayfalar)

C-SERIES MDS 9124 FABRIC SWITCH

The MDS 9124 switches have fixed configurations with 8, 16, and 24 full rate 4-Gbps fibre

channel ports. The 8 and 16 port switches can be upgraded in 8 port increments with a software

expansion license.

C-SERIES MDS 9124e FABRIC SWITCH FOR HP C-CLASS

BLADESYSTEM

The MDS 9124e 12-port fabric switch and the MDS 9124e 24-port fabric switch for HP c-Class

BladeSystem have fixed configurations with 8-internal/4-external or 16-internal/8-external full

rate 4-Gbps fibre channel ports. The 12-port switch can be upgraded to the 24-port switch with a

software expansion license.

Note: Refer to HP.com for the latest supported software for the c-Class Onboard Administrator firmware

and mezzanine adaptors

How to acquire a port license on the MDS 9124e

1. Log into the switch using either the management console or telnet

2. Enter your network-admin privileged account by entering your login name and

password

switch login: admin

Password: <admin password>

3. Enter the following command to verify which ports are eligible to receive a license:

switch# show port-license

4. Enter into the configuration mode by entering the following command:

switch# config terminal

5. Enter the following commands to enable a port license:

In this example, bay2 acquires a port license.

switch(config)# interface bay2

switch(config-if)# shut

switch(config-if)# port-license acquire

switch(config-if)# no shut

switch(config-if)# exit

switch(config)# exit

6. Enter the following command to verify the desired port acquires a license:

switch# show port-license

7. Copy the running configuration into the startup configuration by entering the

following:

switch# copy running-config startup-config

Note: The running configuration overwrites the startup configuration.

MDS Multilayer Director & Multilayer Fabric Switches Release Notes