Cisco 9124 - mds multilayer fabric switch Donanım Kurulum Kılavuzu - Sayfa 29

Anahtar Cisco 9124 - mds multilayer fabric switch için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Cisco 9124 - mds multilayer fabric switch 36 sayfaları. Mds 9000 series
Ayrıca Cisco 9124 - mds multilayer fabric switch için: Teknik Özellikler (2 sayfalar), Veri Sayfası (9 sayfalar), Teknik Özellikler (3 sayfalar), Yapılandırma Kılavuzu (49 sayfalar), Yayın Notu (48 sayfalar), Yayın Notu (44 sayfalar), Yayın Notu (36 sayfalar), Yayın Notu (22 sayfalar), Yayın Notu (3 sayfalar), Yayın Notu (40 sayfalar), Manuel (16 sayfalar)

Chapter 2

Installing the Cisco MDS 9100 Series

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Removing and Installing AC Power Supplies

This section provides instructions for removing and installing the AC power supplies for the Cisco MDS

9100 Series switches.

Power supplies for the Cisco 9100 Series switches look similar but they differ slightly. Be sure to use

Caution

the correct power supply designated for your Cisco 9100 Series switch. Using an incorrect power supply

will not provide redundant power in the case of a power supply failure.

Removing Power Supplies

To remove a AC power supply, follow these steps:

Turn the power switch to the off (0) position on the power supply that you are removing.

Step 1

Disconnect the power cord from the power source.

Step 2

Loosen the captive screw.

Step 3

Grasp the power supply handle and slide the power supply out of the switch. See

Step 4

Figure 2-24

Installing Power Supplies

To install the dual 300-W AC-input power supplies, follow these steps:

Ensure that the system (earth) ground connection has been made.

Step 1

OL-21514-01

Cisco MDS 9100 Series AC Power Supply

AC OK

DC OK

Removing and Installing Components

Cisco MDS 9100 Series Hardware Installation Guide

Figure

2-24.

2-29