Cisco Aironet 350 Series Manuel - Sayfa 7

Anahtar Cisco Aironet 350 Series için çevrimiçi göz atın veya pdf Manuel indirin. Cisco Aironet 350 Series 10 sayfaları. Managed switches
Ayrıca Cisco Aironet 350 Series için: Hızlı Başlangıç Kılavuzu (12 sayfalar), Sürüm Notları (14 sayfalar), Hızlı Başlangıç Kılavuzu (16 sayfalar), Hızlı Başlangıç Kılavuzu (12 sayfalar), Hızlı Başlangıç Kılavuzu (12 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Tanıyalım (16 sayfalar), Hızlı Başlangıç Kılavuzu (5 sayfalar)

Sayfayı Yazdır
Cisco Aironet 350 Series Manuel
configure
CBS350-2#
Step 3
To enter the context of the specified stack unit or all stack units, enter the stack unit command in
the Global Configuration mode by entering the following:
stack unit [unit-id | all]
CBS350-2(config)#
In this example, stack unit 1 is used.
Step 4
Enter the stack configuration command to configure the stack ports and unit ID after reboot by
entering the following:
stack configuration {[links ports-list] [unit-id | auto]}
CBS350-2(unit)#
The options are:
ports-list - a list of one or more stack ports separated by comma, or a range of sequential
ports marked by dash.
Links - Choose port list to be used as stack links after reload.
unit-id - Choose the unit ID to be used after reload. The range is 1 to 4. You can use auto to
enable stack auto numbering feature.
Step 5 (Optional)
To remove stack configuration settings on the switch, use the no stack configuration command by
entering the following:
no stack configuration
CBS350-2(unit)#
Step 6
Enter the end command to go back to the Privileged EXEC mode of the switch.
end
CBS350-2(unit)#
Step 7 (Optional)
To display the stack configuration settings, enter the following:
show stack configuration
CBS350-2#
In this example, the Unit 2 switch now uses te3-4 as stack links. These settings will take effect
after the switch reboots.
Step 8 (Optional)
In the Privileged EXEC mode of the switch, save the configured settings to the startup
configuration file, by entering the following: