Cisco ASR 920 series Kurulum Kılavuzu - Sayfa 6

Anahtar Cisco ASR 920 series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco ASR 920 series 36 sayfaları. Aggregation services router
Ayrıca Cisco ASR 920 series için: Başlarken (6 sayfalar), Kurulum Kılavuzu (42 sayfalar), Donanım Kurulum Kılavuzu (46 sayfalar), Manuel (36 sayfalar)

Sayfayı Yazdır

Installing the Router in a Rack

Step 2

Position one of the brackets against the chassis side, and align the screw holes.

Step 3

Secure the bracket to the chassis with the screws removed when performing Step 1. The recommended

maximum torque is 10 in.-lb.

Step 4

Repeat Step

Installing the Router Chassis in the Rack

Note

Ensure adequate air flow when mounting the router in a rack. For more information, see the

Guidelines" section on page

Note

Install the cable guides before installing the router in a 19-inch EIA rack. See

Guides, page

To install the router chassis in the equipment rack, perform these steps:

Position the chassis in the rack as follows:

Step 1

•

Step 2

Align the mounting holes in the bracket (and optional cable guide) with the mounting holes in the

equipment rack.

The following figure shows how to install the Cisco ASR 920 Series Router in a 19-inch EIA rack.

Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide

3-6

and Step

for the other bracket.

11.

3-7.

If the front of the chassis (front panel) is at the front of the rack, insert the rear of the chassis between

the mounting posts.

If the rear of the chassis is at the front of the rack, insert the front of the chassis between the

mounting posts.

Chapter 3

Installing the Cisco ASR 920 Series Router

Attaching the Cable

"Air Flow

OL-32751-01