Cisco ASR 920 series Kurulum Kılavuzu - Sayfa 42

Anahtar Cisco ASR 920 series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco ASR 920 series 42 sayfaları. Aggregation services router
Ayrıca Cisco ASR 920 series için: Kurulum Kılavuzu (36 sayfalar), Başlarken (6 sayfalar), Donanım Kurulum Kılavuzu (46 sayfalar), Manuel (36 sayfalar)

Sayfayı Yazdır

1. Connect to the 10/100/1000 Ports

Connect Ethernet Cables

The router interface modules support RJ-45 and Ethernet SFP ports.

The RJ-45 port supports standard straight-through and crossover Category 5 unshielded twisted-pair (UTP)

cables. Cisco does not supply Category 5 UTP cables; these cables are available commercially.

To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety,

Warning

connect the Gigabit Ethernet ports only to intra-building or unexposed wiring or cable. The intrabuilding

cable must be shielded and the shield must be grounded at both ends. The intra-building port(s) of the

equipment or subassembly must not be metallically connected to interfaces that connect to the OSP or its

wiring. These interfaces are designed for use as intra-building interfaces only (Type 2 or Type 4 ports as

described in GR-1089-CORE) and require isolation from the exposed OSP cabling. The addition of Primary

Protectors is not sufficient protection in order to connect these interfaces metallically to OSP wiring.

Follow these steps to connect a cable to a copper Gigabit Ethernet port:

SUMMARY STEPS

1. Confirm that the router is powered off.

2. Connect one end of the cable to the Gigabit Ethernet port on the router.

3. Connect the other end to the BTS patch or demarcation panel at your site.

DETAILED STEPS

Step 1

Confirm that the router is powered off.

Step 2

Connect one end of the cable to the Gigabit Ethernet port on the router.

Step 3

Connect the other end to the BTS patch or demarcation panel at your site.

Connect Cables to SFP Modules

For information on connecting cables to Cisco optical and Ethernet SFP interfaces, see:

http://www.cisco.com/en/US/partner/products/hw/modules/ps5455/prod_installation_guides_list.html.

Connector and Cable Specifications

For more information on cable specifications and pinouts, see

Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide

Installing the Cisco ASR 920 Series Router

Chapter 5, "Troubleshooting"