Cisco C3850-NM-4-1G Manuel - Sayfa 11

Anahtar Cisco C3850-NM-4-1G için çevrimiçi göz atın veya pdf Manuel indirin. Cisco C3850-NM-4-1G 15 sayfaları.
Ayrıca Cisco C3850-NM-4-1G için: Yükleme (17 sayfalar)

Sayfayı Yazdır

Installing a Network Module

• When you insert several pluggable transceiver modules in multiple switch ports, wait for 5 seconds

between inserting each module. This will prevent the ports from going into error disabled mode. Similarly,

when you remove a pluggable transceiver module from a port, wait for 5 seconds before reinserting it.

Procedure

Step 1

Attach an ESD-preventive wrist strap to your wrist and to an earth ground surface.

Step 2

Find the send (TX) and receive (RX) markings that identify the top of the transceiver module.

On some modules, the send and receive (TX and RX) markings might be shown by arrows that show the

direction of the connection.

Step 3

If the pluggable transceiver module has a bale-clasp latch, move it to the open, unlocked position.

Step 4

Align the module in front of the slot opening, and push until you feel the connector snap into place.

Figure 2: Installing a Pluggable Transceiver Module in the Network Module

Step 5

If the module has a bale-clasp latch, close it to lock the module in place.

Step 6

Remove the dust plugs and save.

Step 7

Connect the transceiver cables.

Installing a Cisco Pluggable Transceiver Module

Installing a Network Module