Accustic Arts AMP I MK 2 Manuel - Sayfa 8

CD Çalar Accustic Arts AMP I MK 2 için çevrimiçi göz atın veya pdf Manuel indirin. Accustic Arts AMP I MK 2 14 sayfaları.
Ayrıca Accustic Arts AMP I MK 2 için: Manuel (10 sayfalar)

Sayfayı Yazdır

6 Reproduction of a CD

6.1 Start-up and loading a CD

First of all switch-on the device by pressing the mains power switch 2 and set the rotary switch 10 to the

position OPERATE and the blue LED 7 in the middle lights up. The laser unit of the DRIVE I – MK 2 now

initialises for approx. 2 seconds and finds out if a CD is loaded or not. If no CD is inserted, then the

disc

display shows

. If there is a CD in the device, then after initialisation of the laser the number of

music tracks and the total time of the CD are displayed. Then, for example, the display shows

65:20

This means that the inserted CD has 10 music tracks and the complete total playing time is 65 minutes

and 20 seconds.

If you wish to load a CD or exchange a CD which is already loaded, then first of all slowly push the cover

11 to the back. On the display there now appears

Open

, indicating the cover is open. Now remove

the clamper 12 by lifting it upwards. Please note that the clamper has an integrated magnet and therefore

sits rather firmly on the CD. After removing the clamper you may now remove a CD. When removing the

CD take care not to touch the laser unit. Finger prints and dirt on the laser unit can disturb the scanning

process and so negatively affect the sound.

Insert the desired CD and now place the clamper 12 in the middle of the CD. Make sure that the clamper

locks correctly into position, otherwise playback is not possible. Close the cover 11 completely again.

After the closing process the laser initialises again, i.e. it scans the inserted CD and determines the

number of music tracks as well as the total time. If no CD is loaded or the clamper 12 is not correctly

disc

fixed on to the CD, the display shows

6.2 Basic functions of the DRIVE I – MK 2

After the CD has been correctly inserted the device is now ready for operation and you can start the CD

by shortly pressing the push button PLAY.

To stop the CD please press the push button STOP.

To jump or go to the next track please use the left rotary switch SKIP by shortly turning it clockwise and

then release. Should you wish to jump back one or several tracks, turn the rotary switch once or several

times shortly to the left (anticlockwise).

Should you wish to interrupt your music listening for a short time (e.g. a number of minutes or a just for a

few hours), operate the right rotary switch 10 and turn it left to the STANDBY position. In the standby

function now only the blue standby LED 8 is lit. The lighting for the upper logo and the display goes out.

For a complete start-up of the DRIVE I – MK 2, set the rotary switch 10 again to the position OPERATE.

IMPORTANT SAFETY PRECAUTIONS:

If you wish to discontinue your music listening for a longer period (more than 1 hour) the device

must be completely disconnected from the mains power and this is done by pressing the mains

power switch 2.

The functions SKIP, STOP and PLAY can also be operated using the IR remote control. The functions

STANDBY and OPERATE are not available via the remote control.