Cisco Catalyst 2900 Series XL Hızlı Başlangıç Kılavuzu - Sayfa 7
Anahtar Cisco Catalyst 2900 Series XL için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco Catalyst 2900 Series XL 13 sayfaları. 10/100 autosensing fast ethernet switches
Ayrıca Cisco Catalyst 2900 Series XL için: Hızlı Başlangıç Kılavuzu (12 sayfalar), Genel Bakış (6 sayfalar)
Sayfayı Yazdır
The initial configuration displays:
The following configuration command
script was created:
interface VLAN1
ip address 172.20.153.36 255.255.255.0
ip default-gateway 172.20.153.01
enable secret 5 $1$M3pS$cXtAlkyR3/6Cn8/
snmp community private rw
snmp community public ro
cluster enable cls_name
end
Use this configuration? [yes/no]:
8
Verify that the addresses are correct.
9
Enter Y, and press Return.
If the addresses are not correct, enter
N, press Return, and begin again at
Step 1.
Where to Go Next
After you complete the setup program, the
switch can run the created default
configuration. If you want to change this
configuration or want to perform other
management tasks, use one of these tools:
•
Command-line interface (CLI)
•
CVSM and Cluster Management
software
To use the CLI, enter commands at the
switch> prompt. Refer to the Cisco IOS
Desktop Switching Software Configuration
Guide or the Cisco IOS Desktop Switching
Command Reference (online only) for
configuration information.
To use CVSM, go to Section 4, "Access the
Switch from Your Browser."
5