Digiscan Labs iPROTECT 1216 Manuel - Sayfa 3

Güvenlik Sensörleri Digiscan Labs iPROTECT 1216 için çevrimiçi göz atın veya pdf Manuel indirin. Digiscan Labs iPROTECT 1216 13 sayfaları. Counter surveillance 3-band rf detector

Sayfayı Yazdır
Wi-Fi and 3G
The iProtect 1216 has a significantly higher sensitivity to the 3G, Wi-Fi and Bluetooth bugging devices
compared to conventional RF detectors. This advantage was achieved with the help of the additional
radio frequency paths in the circuit dedicated to the specific frequency spans. Therefore Wi-Fi,
Bluetooth and a number of other wireless protocols operating within the 2.4/5GHz bands are detected
at an increased distance
Signature
In addition to drawing a bargraph the iProtect 1216 can identify some types of signals and show a
corresponding message on the display. By combining information coming from the extra RF paths and
from the audio signature the 1216 identifies the following signals: cordless DECT device in an "idle"
state, active DECT device, GSM, 3G, Wi-Fi/Bluetooth
Detects all types of RF transmissions including analog and digital, audio
and video
F requency range 50 MHz – 12 GHz
S eparation into 3 bands helps to avoid loss of sensitivity near strong
interference
A LL BANDS and ONE BAND display modes
H igh sensitivity to 3G and wireless protocols (Wi-Fi, Bluetooth, etc.)
W orking modes: SILENT, AUDIO and ALARM
A djustable alarm threshold
P ortable, reliable and easy-to-use
T he BARGRAPH shows the momentary RF level
T he HISTOGRAM displays the RF signal over 5 seconds (in 'ONE BAND'
display mode)
T he SIGNATURE displays the possible signal type
B uilt-in directed microwave antenna
S hock-resistant CNC milled duralumin housing
R echargeable Li-Ion battery with resource of 6 hours
C ontrolled by microcontrollers
2 x built-in OLED displays

ALL FEATURES

3