Digisol DG-CS4616F Kurulum Kılavuzu - Sayfa 16

Anahtar Digisol DG-CS4616F için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Digisol DG-CS4616F 17 sayfaları. Giga layer 3 switch

DG-CS4616F Installation Guide

Fig 2- 4 Attaching power cable to DG-CS4616F

1. Insert one end of the power cable provided in the accessory kit into the power source

socket (with overload and leakage protection), and the other end to the power socket in

the back panel of the switch.

2. Check the power status indicator in the front panel of the switch. The corresponding

power indicator should light. DG-CS4616F is self-adjustable for the input voltage. As soon

as the input voltage is in the range printed on the switch surface, the switch can operate

correctly.

3. When the switch is powered on, it executes self-test procedure and startups.

Caution!

The input voltage must be within the required range, otherwise the switch can be

damaged or malfunction. Do not open the switch shell without permission. It can cause

physical injury.

2.3.6 Ground Cable Connection

Grounding: The chassis of the equipment must be grounded properly so that the

lightning can flow to the ground, which improves the capability of the chassis for resisting

the electromagnetic interference.

1. Ensure that the grounding cable is connected correctly so that the equipment is

protected against lightning and interference. The correct connection of the grounding

cable is an important measure to ensure the human safety.

2. Connect the chassis to the ground by using a grounding cable. The grounding

resistance must be smaller than 0.10 ohms and the gauge of the grounding cable must be

greater than 10 AWG and the length is 50 cm.

Chapter 2-10