Sharp Carousel II R-1820 Kullanım Kılavuzu - Sayfa 10

Mikrodalga Fırın Sharp Carousel II R-1820 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Sharp Carousel II R-1820 32 sayfaları. Over the range convection microwave oven

Sayfayı Yazdır

Operation

of Auto-Touch ® Control Panel

Your new Sharp Auto-Touch convection microwave oven uses a microp_,

the electronic brain that provides

a wide variety of cooking programs which could not be achieved by _tional

cont.01 methods. The operation

of the oven is controlled by touching the appropriate pads arranged on l_

surface of the corm'ol panel.

An entry signal tone should be heard each time you touch the control panel to make a correct entry. If you do not

hear this sound:

You have not used enough pressure in touching the pad.

2) You have made more entries than the control panel will accept.

3) You have made an incorrect entry.

In addition to the ent-- D, signal tone, an audible signal will sound for approximately 2 seconds at the end of the cooking

cycle.

After cooking or using the minute timer, the time of day will appear on the display.

"/',,take. sure the oven is_

into a 3-pronged 115-120 volt household o.,'tlet. When the oven is plugged in,

the display will show _,

flashing on and off each second. Touch the STOP/CLEARpad: _

will appear°

* You cannot program the o,_n if the door is not closed fimlly_

'_ This oven can be programmed for up to 4 automatic sequence& (EX.: Microwave !v'ed - Microwave High - Pause

- High Mix RoasO

* During cooking, the program cannot be changed until the STOPICLEAR pad is touched twice. All functions are

locked in to prevent accidental changes.

" During cooking, when the door is opened, the cooking time in the readout automatically stops. The cooking

time starts to count down again when the door is closed and the START pad is touched.

* I! the electrical power to your microwave oven is interrupted, the display will intermittently show _

after

the power is reinstated. If this occurs during cooking, the program will be erased° Simply reset the_or

the

correct time of day and reprogram.

[ To Set the Clock ]

* Suppose you want to enter the correct time of day 12:30 (A.M. or PoM.)

NOTE: 1o "[his

[Step I

2,1

_ 3, I

Procedure

Touch _e AUTO

START/CLOCK

pad°

Enter the correct time of day by touch-

ing the nurr_rs

in sequer'_eo

Touch AUTO START/CLOCK pad again_

Pad Order

ct£r_

[ _ii_

SrANr 1

is a 12 hour clock. _

will appear in the readout i_ttempt

to enter an incorrect clock

t_me.. For example, if you try to en_r 8:6! or 13:00, [ /_RRORI and tie incorrect clock time will

appear repeatedly° To erase 1.. E RROR l, touch the STOP/CLEAR pad. tfyou accidently ouch more

than 4 number pads, the last 4 numbers you have touct-_

will appear on the display,

If the oven is in cooking or minute timer mode and you wish to know the time of day, simply touch the

AUTO STARTiCLC__Kpad_ As long as your finger is touching the pad, tie time wilt be displayed.

This checking operation does not interfere with the cooking time, oven temperature, or minute

timer.