Sharp Carousel R-1405, Carousel R-1406 Kurulum Talimatları Kılavuzu - Sayfa 10
Mikrodalga Fırın Sharp Carousel R-1405, Carousel R-1406 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Sharp Carousel R-1405, Carousel R-1406 32 sayfaları. Over the range microwave oven
Ayrıca Sharp Carousel R-1405, Carousel R-1406 için: Şartname (2 sayfalar), Servis Kılavuzu (48 sayfalar)
Sayfayı Yazdır
U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S
8 VENTILATION SYSTEM (PREPARING OVEN FOR
INSTALLATION)
This Microwave Oven/Hood is designed for adaptation to three types of hood ventilation systems. Select the type
required for your installation.
Recirculating — non-vented, ductless. Follow installation procedure (A). Recirculating requires the use of the
Charcoal Filter.
Horizontal Exhaust — outside ventilation. Follow installation procedure (B).
Vertical Exhaust — outside ventilation. Follow installation procedure (C).
(A) RECIRCULATING: NON-VENTED, DUCTLESS
OPERATION
1. The Exhaust Damper Assembly 9 is not required for recirculating operation.
NOTE:
2. The Charcoal Filter should be replaced every 6 to 12 months, depending on use.
3. The Charcoal Filter RK-240 is sold as an accessory. See Page 14 for ordering information.
(B) HORIZONTAL EXHAUST: OUTSIDE VENTILATION
1. Remove 2 screws from back edge and 3 screws from the top center of Fan Cover Bracket. Save 2 screws to be
used later and discard remaining 3. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow
on the Fan Cover Bracket, as shown in Figure 7.
2. Lift Hood Fan Unit carefully and slip wires out of cavity. See Figure 8. CAUTION: Do not pull or stretch hood fan
wiring.
3. Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing the back of the oven. See Figure 9 (A).
Replace Hood Fan Unit into the oven. Be careful not to pinch the wire and the Hood Fan Unit. See Figure 9 (B).
4. Put the wire back into the cavity. See Figure 10.
Figure 7
Figure 9
(A) Rotate 180˚
(B)
Figure 8
Figure 10
10
Save fan cover bracket for
future instructions.