Sharp Carousel R-1514 Kurulum Talimatları Kılavuzu - Sayfa 12

Mikrodalga Fırın Sharp Carousel R-1514 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Sharp Carousel R-1514 40 sayfaları. Over the range stainless
Ayrıca Sharp Carousel R-1514 için: Broşür ve Teknik Özellikler (8 sayfalar), Pişirme Kılavuzu (32 sayfalar), Broşür ve Teknik Özellikler (5 sayfalar), Kurulum Talimatları Kılavuzu (9 sayfalar), Teknik Özellikler (2 sayfalar), Ek Servis Kılavuzu (33 sayfalar), Pişirme Kılavuzu (32 sayfalar), Manuel (40 sayfalar), Ek Servis Kılavuzu (33 sayfalar)

U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S

9 OVEN INSTALLATION

THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUC-

TIONS FOUND ON WALL AND TOP CABINET TEMPLATES.

THE NEXT STEP IS TO READ AND FOLLOW MOUNTING INFORMATION ON WALL AND TOP CABINET

TEMPLATES. THIS OVEN MUST BE ATTACHED TO AT LEAST ONE WALL STUD. SEE WALL CONSTRUC-

TION ON PAGE 6.

WHEN DONE WITH TEMPLATES, PROCEED TO MOUNTING SCALE PLATE SECTION.

MOUNTING SCALE PLATE

Attach 2 Scale Plates ! with tape (not included). See Figure 16 and WALL TEMPLATE for locations.

Figure 16

MOUNTING PLATE

1. Separate 4 Toggle Bolts 2, packed in the INSTALLATION HARDWARE, from the Toggle Nuts.

2. Match 5/8" holes (not in studs), drilled through WALL TEMPLATE into wall to corresponding holes on Mounting

Plate.

3. Insert Toggle Bolts into matched openings on Mounting Plate. Put Toggle Nuts on Toggle Bolts. See Figure 17.

4. Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and Bolts

through the holes in the wall with the Toggle Nuts closed. Figure 18. Use Wood Screws 1 to attach the Mount-

ing Plate to studs.

NOTE: Before insertion, be sure you leave a space more than the thickness of the wall between the Mounting

Plate and the end of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the

Toggle Nut will not be able to open on the other side of the wall. Also, once a Toggle Nut opens, it cannot be

withdrawn from the hole; therefore make sure all of the Toggles are in the correct position before

insertion.

5. Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward you

and turn clockwise to tighten. Figure 19.

Figure 17

Mounting

Plate

Scale Plates

Mounting Plate

Figure 18

Space more than

wall thickness

Wall

Figure 19