Sharp Carousel R-1871 Kullanım Kılavuzu - Sayfa 28

Mikrodalga Fırın Sharp Carousel R-1871 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Sharp Carousel R-1871 32 sayfaları. Over-the-range microwave oven/hood system
Ayrıca Sharp Carousel R-1871 için: Broşür ve Teknik Özellikler (8 sayfalar), Kurulum Kılavuzu (9 sayfalar), Servis Kılavuzu Eki (24 sayfalar), Kurulum Talimatları Kılavuzu (8 sayfalar)

Sayfayı Yazdır

C L E A N I N G A N D C A R E

FAN

The fan will automatically start when heat rises from

range surface units or burners and when convection,

high mix, low mix or the broil settings are used. This

protects the microwave oven from excessive tempera-

ture rise. The fan will stay on until the temperature

decreases. It cannot be turned off manually during

this time.

For other uses, select either high or low speed.

PRECAUTIONS FOR PROPER USE:

1. DO NOT leave range unattended while using high

temperatures. Automatic fan may start and provide

excessive air to the surface units. This may cause

spattering or boilover.

2. Avoid burning food.

3. Keep grease filters clean.

LIGHT

1. To replace light bulbs, first disconnect power to the

oven at the circuit breaker panel or by unplugging.

2. To release cover remove the screw on the light cover.

(See illustration.)

3. Replace bulbs only with equivalent watt bulbs

available from a Sharp Authorized Servicer or parts

distributor. Bulbs are also available at most hard-

ware stores or lighting centers. DO NOT USE A BULB

LARGER THAN 30 WATTS.

4. Close light cover and secure with screw removed in

step 2.

CAUTION: Light cover may become very hot. Do not

touch glass when light is on. Do not use light for long

time use such as a night light.

Light cover

Light bulbs

Screw

CHARCOAL FILTER

Charcoal Filter, Sharp Part Number RK-220 is used for

No-vented, recirculated installation. The filter should be

changed every 6 to 12 months depending on use.

1. Disconnect power to the oven at the circuit breaker

panel or by unplugging.

2. Remove 3 screws that secure louver.

3. Remove louver by inserting flat edge screwdriver

over each tab depressing the tab down and moving

louver away from unit.

4. Pull the louver away from the oven.

5. Slide Charcoal Filter into position on support tabs.

6. Push louver back into place and gently snap tabs

into place by hand (engaging both the bottom and

top tabs) and replace the 3 screws to secure louver.

OVEN LIGHT

Remove the louver per instructions 1-4 above and

charcoal filter, if used.

5. Slide the light cover forward and lift up.

6. Remove old light bulb and replace only with an

equivalent watt bulb available from a Sharp

Authorized Servicer or parts distributor. Bulbs are

also available at most hardware stores or lighting

centers. DO NOT USE A BULB LARGER THAN

30 WATTS.

7. Replace the oven light cover and charcoal filter, if

used; push louver back in place (engaging both the

bottom and top tabs) and replace the louver

mounting screws.

Screw

Charcoal filter

Oven light

Louver

Top tab

Screw

Bottom tab