Sharp Carousel R-231Z Kullanım Kılavuzu ve Pişirme Kılavuzu - Sayfa 7
Mikrodalga Fırın Sharp Carousel R-231Z için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Pişirme Kılavuzu indirin. Sharp Carousel R-231Z 24 sayfaları. Carousel
Sayfayı Yazdır
BEFORE OPERATING
Getting Started (Energy Save Mode)
Your oven has two operating modes, Energy Save Mode and Clock Set Mode.
In Energy save Mode nothing will appear on the digital display and in Clock Set Mode the time will be shown.
The oven comes pre-set for Energy Save Mode so when you first plug it in nothing will appear on the digital display.
To operate the oven in energy save mode.
1. Plug in the oven. Nothing will appear on the display at this time.
2. Open the door the oven lamp will be light. The display will show "0".
3. Close the door the oven lamp will be off. The display will show "0".
NOTE
If you do not operate the oven for 3 minutes or more (i.e. after closing the door, pressing the STOP/CLEAR
key, or at the end of cooking), you will not be able to operate the oven until you open and close the oven
door. Whilst in Energy Save Mode the display is blank.
You can change to Clock Set Mode if you prefer, If you decide to set the clock, Energy Save Mode does not work.
Clock Setting
* To enter the present time of day 11:34 (AM or PM).
Step
Procedure
Press the TIMER/CLOCK pad.
1
Enter the correct time of day by pressing the
numbers in sequence.
2
Press the TIMER/CLOCK pad again.
3
This is a 12 hour clock. If you attempt to enter an incorrect clock time (eg. 13:45), Err will appear in the display.
Press the STOP/CLEAR pad and re-enter the time of day (eg. 1:45).
If you wish to know the time of day during the cooking or timer mode, press the TIMER/CLOCK pad. As long as your
finger is pressing the TIMER/CLOCK pad, the time of day will be displayed.
Stop/Clear
Press the STOP/CLEAR pad once to:
1. Stop the oven temporarily during cooking.
2. Clear if you make a mistake during programming.
To Cancel a Programme During Cooking
Press the STOP/CLEAR pad twice.
Pad Order
The dots (:) will flash on and off.
6
Display