Sharp CD G14000 Kullanım Kılavuzu - Sayfa 41
Stereo sistemi Sharp CD G14000 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Sharp CD G14000 48 sayfaları. Mini component system
Sayfayı Yazdır
Headphones
Before plugging in or unplugging the headphones, reduce the
volume.
Be sure your headphones have a 1/8" (3.5 mm) diameter plug and
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging
in
the
headphones
automatically. Adjust the volume using the VOLUME control.
disconnects
the
speakers
5
4
3
2
1
REMOTE
SENSOR
TIMER
POWER
ON/ STAND-BY
OPEN/
c
CLOSE
CD
5
TAPE
(1
2)
4
TUNER
(BAND)
3
PRESET
PRESET
2
AUDIO
IN
1
TUNING
TUNING
VOL.
VOL.
PLAYBACK (PLAY & S TOP)
RECORD/PLAYBACK
PHONES
AUDIO IN
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
General
Symptom
The clock is not set to the
correct time.
When a button is pressed,
the unit does not respond.
No sound is heard.
CD player
Symptom
Playback does not start.
Playback stops in the
middle or is not performed
properly.
Playback sounds are
skipped, or stopped in the
middle of a track.
Possible cause
Did a power failure occur? Reset
the clock. (Refer to page 19.)
Set the unit to the power stand-by
mode and then turn it back on.
If the unit still malfunctions, reset
it. (Refer to page 43.)
Is the volume level set to "0"?
Are the headphones connected?
Are the speaker wires
disconnected?
Possible cause
Is the disc loaded upside down?
Does the disc satisfy the
standards?
Is the disc distorted or
scratched?
Is the unit located near excessive
vibrations?
Is the disc very dirty?
Has condensation formed inside
the unit?
CD-G14000
41