Sharp CD-BA300 Kullanım Kılavuzu - Sayfa 27
Stereo sistemi Sharp CD-BA300 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Sharp CD-BA300 32 sayfaları. Cdba300 operation manual
Ayrıca Sharp CD-BA300 için: Hızlı Kılavuz (4 sayfalar)
Sayfayı Yazdır
Timer and Sleep Operation (continued)
6
Press the TUNING/TIME (W W W W W or X X X X X ) button to specify the minute,
then press the MEMORY/SET button.
7
The unit will enter the timer stand-by mode automatically.
To cancel the timer playback/timer recording:
Press the ON/STAND-BY button to turn the power on.
8
When the preset time is reached, playback or recording will start.
The volume will increase gradually until it reaches the volume you were listen-
ing at before your system enters the timer stand-by mode.
9
In timer playback:
If you select CD or TAPE, the unit will enter the stand-by mode after the play-
back.
If you select TUNER or VIDEO/AUX, it will enter the stand-by mode one hour
after the timer playback starts.
In timer recording:
When recording tape reaches its end, the timer recording will end, and the
unit will enter the stand-by mode.
To reset or change the timer setting:
Perform "Timer playback or Timer recording" from the beginning.
Notes:
Once the time is set, the setting will be retained until a new time is entered.
When performing timer playback or recording using another unit connected to the
VIDEO/AUX jacks, select "VIDEO/AUX" in step 2. At this time, only this unit will be
turned on or enter the power stand-by mode automatically. (Another unit will not be
turned on or turned off.)
BA300_P26_28
27
Sleep operation
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until "SLEEP" is dis-
played.
To change the sleep time:
While the sleep time is displayed, press the TUNING/TIME (X or W) button.
(Maximum: 3 hours - Minimum: 1 minute)
3 hours - 5 minutes
5-minute intervals
5 minutes - 1 minute
1-minute intervals
3
Press the MEMORY/SET button.
4
Your system will enter the power stand-by mode automatically
after the preset time has elapsed.
The volume will be turned down 1 minute before the sleep operation finishes.
To cancel the sleep operation:
Press the ON/STAND-BY button while sleep operation is performed.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button while sleep operation is performed.
The remaining sleep time is displayed for about 5 seconds.
Note
:
Once the sleep time is set, it will remain unchanged until the setting is changed.
Listening to the Radio (See page 20)
01.2.13, 2:14 PM
27