Sharp CD-C462C Servis Kılavuzu - Sayfa 2
Stereo sistemi Sharp CD-C462C için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Sharp CD-C462C 44 sayfaları.
Sayfayı Yazdır
CD-C462/C462C
FOR A COMPLETE DESCRIPTION OF THE OPERATION OF THIS UNIT, PLEASE REFER
TO THE OPERATION MANUAL.
IMPORTANT SERVICE NOTES (For U.S.A.Only)
BEFORE RETURNING THE AUDIO PRODUCT
(Fire & Shock Hazard)
Before returning the audio product to the user, perform the
following safety checks.
1. Inspect all lead dress to make certain that leads are not
pinched or that hardware is not lodged between the chassis
and other metal parts in the audio product.
2. Inspect all protective devices such as insulating materials,
cabinet, terminal board, adjustment and compartment
covers or shields, mechanical insulators etc.
3. To be sure that no shock hazard exists, check for leakage
current in the following manner.
* Plug the AC line cord directly into a 120 volt AC outlet.
* Using two clip leads, connect a 1.5k ohm, 10 watt resistor
paralleled by a 0.15µF capacitor in series with all exposed
metal cabinet parts and a known earth ground, such as
conduit or electrical ground connected to earth ground.
* Use a VTVM or VOM with 1000 ohm per volt, or higher,
sensitivity to measure the AC voltage drop across the
resistor (See diagram).
* Connect the resistor connection to all exposed metal parts
having a return path to the chassis (antenna, metal cabinet,
screw heads, knobs and control shafts, escutcheon, etc.)
and measure the AC voltage drop across the resistor.
CD-C462/C462C
General
Power source:
AC 120 V, 60 Hz
Power consumption:
110 W
Dimensions:
Width; 10-5/8" (270 mm)
Height; 11-13/16" (303 mm)
Depth; 13-13/16" (350 mm)
Weight:
14.7 lbs. (6.7 kg)
Amplifier section
Output power:
Front speakers; 40 W minimum RMS into
6 ohms from 60 Hz to 20 kHz with no
more than 10 % total harmonic distortion.
Center speaker; 20 W
(1 kHz, 10 % T.H.D.)
Rear speakers; 20 W (total)
(1 kHz, 10 % T.H.D.)
Output terminals:
Front speakers; 6 ohms
Center speakers; 4 ohms
Rear Speakers; 8 ohms
Headphones; 16-50 ohms
(recommended; 32 ohms)
Input terminal:
Video/Auxiliaary (audio signal);
500 mV/47 kohms
Tuner section
Frequency range:
FM; 87.5 - 108 MHz
AM; 530 - 1,720 kHz
Cassette deck section
Frequency response:
50 - 14,000 Hz (Normal tape)
Signal/noise ratio:
55 dB (TAPE 1, playback)
50 dB (TAPE 2, recording/playback)
Wow and flutter:
0.15 % (WRMS)
Compact disc player section
Type:
3-disc multi-play compact disc player
Signal readout:
Non-contact, 3-beam semiconductor
laser pickup
D/A Converter:
1-bit D/A converter
Frequency response:
20 - 20,000 Hz
Dynamic range:
90 dB (1 kHz)
TO EXPOSED
METAL PARTS
All check must be repeated with the AC line cord plug connection
reversed.
Any reading of 0.3 volt RMS (this corresponds to 0.2 milliamp.
AC.) or more is excessive and indicates a potential shock
hazard which must be corrected before returning the audio
product to the owner.
SPECIFICATIONS
Front speaker section
CP-C462
Type:
Maximum input power:
Impedance:
Dimensions:
Weight:
Center speaker section
GBOXS0006AWM4
Type:
Maximum input power:
Impedance:
Dimensions:
Weight:
Rear speaker section
GBOXS0007AWM4
Type:
Maximum input power:
Impedance:
Dimensions:
Weight:
Specifications for this model are subject to change without prior notice.
– 2 –
VTVM
AC SCALE
1.5k ohms
10W
0.15 µ F
TEST PROBE
CONNECT TO
KNOWN EARTH
GROUND
3-way 5-1/8" (130 mm) woofer and 2" (50
mm) tweeter and super tweeter
80 W
6 ohms
Width; 7-7/8" (200 mm)
Height; 11-13/16" (300 mm)
Depth; 10" (253 mm)
5.9 lbs. (2.7 kg)/each
4" (100 mm) full range speaker
40 W
4 ohms
Width; 10-5/16" (262 mm)
Height; 5-3/4" (145 mm)
Depth; 7-15/16" (201 mm)
2.6 lbs. (1.2 kg)
4" (100 mm) full range speaker
20 W
8 ohms
Width; 6-3/4" (170 mm)
Height; 4-13/16" (122 mm)
Depth; 6-15/16" (176 mm)
1.5 lbs. (0.7 kg)/each