Sharp CD-PC3500 Kullanım Kılavuzu - Sayfa 21

Stereo sistemi Sharp CD-PC3500 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Sharp CD-PC3500 24 sayfaları. Sharp mini component system cd-pc3500 operation manual
Ayrıca Sharp CD-PC3500 için: Hızlı Kılavuz (2 sayfalar)

Sayfayı Yazdır
Sharp CD-PC3500 Kullanım Kılavuzu
(Continued)
(Main unit operation)
MEMORY/
SET
TIMER/
SLEEP
TUNING/
TIME
(
)
2
3

USING EXTERNAL UNITS

To the line output jack
Commercially available digital cable
Sleep operation
The radio, compact disc and cassette deck can all be turned off
automatically.
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until "SLEEP" is
displayed.
To change the sleep time:
W
While the sleep time is displayed, press the TUNING/TIME (
or
) button to adjust the time.
(Maximum: 3 hours - Minimum: 1 minute)
The amount of sleep time can also be changed during the sleep
operation.
3 hours - 5 minutes
5 minutes - 1 minute
3
Press the MEMORY/SET button.
4
The unit will turn off automatically after the preset sleep time
has elapsed.
Note:
Once the sleep time is set, it will remain the same duration
until the setting is changed.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button.
To cancel the sleep operation:
Press the ON/STAND-BY button to enter the stand-by mode.
Video/Auxiliary (Audio signal) input
To listen to or record signals from external sources
through this unit:
1
Use an RCA cord to connect the desired external unit to the
VIDEO/AUX 1 or 2 jacks.
(red
When using video equipment (video disc player or VCR), be
sure to connect the audio output to this unit and the video
output to a television.
RCA
2
Press the ON/STAND-BY button to turn the power on.
cord
3
Press the VIDEO/AUX button.
Select either "VIDEO 1" or "VIDEO 2".
4
Operate the external unit.
5
To record the sound from the external unit, perform steps 2
- 4 of the "Recording from the built-in radio" section on page
18.
Note:
To prevent hum interference, do not place this unit near a
television receiver.
CD digital output (optical)
The CD digital signal from this unit can be recorded by
other DAT or MiniDisc recorders.
1
Remove the CD DIGITAL OUT jack cover.
2
Use a commercially available digital cable to connect the unit
to the OPTICAL IN jack of a MiniDisc recorder or a DAT.
3
Put the external unit in the recording mode.
4
Play a CD on this unit.
Note:
Only CD signals can be output.
20
5-minute intervals
1-minute intervals
right channel, white
left channel)
X