Sharp AR-208S Çevrimiçi Kılavuz - Sayfa 6

Hepsi Bir Arada Yazıcı Sharp AR-208S için çevrimiçi göz atın veya pdf Çevrimiçi Kılavuz indirin. Sharp AR-208S 43 sayfaları. Digital multifunctional system
Ayrıca Sharp AR-208S için: Broşür ve Teknik Özellikler (4 sayfalar), Şartname Sayfası (2 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar), Broşür (1 sayfalar)

Basic Printing

If the tray runs out of paper during printing

Printing will automatically resume when paper is loaded in the

tray.

When using the bypass tray, select printer mode with the mode

select key on the machine, load paper as instructed by the

message in the display, and then press the [START] key to

resume printing.

When the 250-sheet paper feed unit is installed:

Note that if the "AUTO TRAY SWITCH" setting in the user

programs is enabled and there is the same size of paper in

another tray, the machine will automatically switch to the other

tray and continue printing.

Cancel a print job

Select printer mode with the [MODE SELECT] key on

the operation panel of the machine, and then press

the [CLEAR] key (

"CANCEL PRINT JOB?" will appear in the

display. Make sure that a checkmark appears in

front of "YES" and press the [ENTER] key.

When the machine is connected to your computer using

Caution

the USB 2.0 (Hi-Speed) ports on each, be sure to read

"System requirements for USB 2.0 (Hi-Speed mode)" in

the Operation Manual.

CONTENTS

) or the [CLEAR ALL] key (

I N D E X

When "Paper Source" is set to "Auto Select"

If "Paper Source" is set to "Auto Select" in the "Paper" tab of the

printer driver setup screen and the correct size of paper for a

print job is not loaded in the machine, the printing procedure will

vary depending on the "FORCED OUTPUT" setting in the user

programs (see "USER PROGRAMS" in the Operation Manual).

When "FORCED OUTPUT" is set to "OFF"

Select printer mode with the mode select key on the machine,

check the message in the display, load paper in the bypass tray,

and then press the [START] key to begin printing.

When "FORCED OUTPUT" is set to "ON"

Printing takes place on the paper loaded in the machine, even

though the paper size is different from the print image size.

(part 2)