Sharp MX-2300N Guide Sorun Giderme Kılavuzu - Sayfa 30
Hepsi Bir Arada Yazıcı Sharp MX-2300N Guide için çevrimiçi göz atın veya pdf Sorun Giderme Kılavuzu indirin. Sharp MX-2300N Guide 44 sayfaları. Sharp mx-2700n, mx-2300n mfp - scan to e-mail instructions
Ayrıca Sharp MX-2300N Guide için: Teknik Özellikler (2 sayfalar), Güvenlik Kılavuzu (28 sayfalar), Belge Dosyalama Kılavuzu (47 sayfalar), E-Posta'ya Tarama Talimatları (7 sayfalar), Yazılım Kurulum Kılavuzu (48 sayfalar)
Sayfayı Yazdır
Problems Related to Machine Operation
Problem
Specified machine
functions cannot be
used.
The operation panel
cannot be used.
28
Point to check
Have functions been disabled by the
administrator?
Is the main power indicator lit?
Did you just power on the machine?
Is the [POWER SAVE] key (
blinking?
Is a cover open or a device separated
from the machine?
Did login fail three times in a row?
Does a message appear indicating that
Auto Login failed?
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
When user authentication is enabled, the functions that
you can use and page counts may be restricted in your
user settings. Check with your administrator.
If the main power indicator is not lit, make sure that the
power plug is firmly inserted in the power outlet, switch
the main power switch to the "on" position, and press
the [POWER] key (
☞
Illustration of the machine (A), (D), and (J) (pages
36 and 37)
After the [POWER] key (
requires about 80 seconds to complete warmup
operation.
During this time functions can be selected, however, a
job cannot be run. Wait until a message appears
indicating that the machine is ready.
)
Auto Power Shut-Off mode has activated. To return the
machine to normal operation, press the [POWER SAVE]
key (
).
☞
Illustration of the machine (A) (page 36)
A warning message will appear when a cover is open or
a device is separated from the machine. Read the
message and take appropriate action.
When "A Warning when Login Fails" is enabled in the
system settings (administrator) and login fails 3 times in
a row, a warning will be displayed and operation will
lock for 5 minutes. After operation unlocks, log in using
the correct user information.
If you do not know your user information, contact your
administrator.
Auto Login failed due to a problem on the network.
Contact your administrator.
If you are the administrator, touch the [Admin Password]
key, log in as an administrator, and temporarily change
the auto login settings in the system settings
(administrator). (Restore the changed settings to their
original state after the network problem has been
solved.)
Solution
) to turn on the power.
) is turned on, the machine