Sharp X-M200DK Kurulum Kılavuzu - Sayfa 15
Hepsi Bir Arada Yazıcı Sharp X-M200DK için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Sharp X-M200DK 38 sayfaları. Digital multifunctional system
Sayfayı Yazdır
[6] MX-FX10/AR-MM9
1. Unpacking
<Before installation>
• For improvement of workability, some description in this manual as
well as components and accessories may change without prior notice.
In this case, refer to the service manual.
Parts included
FAX Expansion Unit: 1
Core: 2
(200V series only)
FAX keyboard: 1
FCC label : 1
(USA, Canada only)
Line Adapter: 1
A-TICK label: 1
(Australia/New Zealand
(Australia,
/Hong Kong only)
New Zealand only)
2. Installation
Turn off the main switch of the copier and then remove the power plug
of the copier from the outlet.
1) Detach the rear cover.
<1>Unscrew two screws from the rear cover.
<2>Push to release the lock shown in the illustration below. Slide to
right and remove the rear cover.
2) Work the rear cover.
Cut and remove the cut-out portion from the rear cover using a tool
such as nippers. Be careful with the tool's direction so that the cut
surface would be flat.
line cable: 1
Screws (S tight): 4
Installing additional memory board (AR-MM9)
* If no need to install, go on to Step 3 to continue FAX Expansion Kit
Installation.
Insert an additional memory board into the socket of FAX Expansion
Unit. Be careful with the inserting direction. Make sure that it is securely
Writing label: 4
inserted.
Operation manual: 1
3) Install FAX Expansion Unit.
<1>Hook the attaching parts of FAX Expansion Unit (two on the right)
onto the copier frame as shown.
<2>Hook the attaching part of FAX Expansion Unit (one on the left)
onto the copier frame as shown.
<3>Push the lower left side of the unit to make sure that connectors of
FAX Expansion Unit and the copier are connected.
<4>Secure the unit onto the copier using four supplied screws (S tight)
as shown.<1>Hook the attaching parts of FAX Expansion Unit (two
on the right) onto the copier frame as shown.
MX-FX10 6 - 1