Sharp SJ-VX79E-SL Kullanım Kılavuzu - Sayfa 5

Buzdolabı Sharp SJ-VX79E-SL için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Sharp SJ-VX79E-SL 24 sayfaları.

Sayfayı Yazdır

Installation

Keep adequate ventilation space around the

refrigerator.

• The figure shows the

minimum required

space for installing

the refrigerator. The

measurement condition

of power consumption

is conducted under

a different space

dimension.

• By keeping greater

space, the refrigerator may consume a less amount

of power consumption.

• If use the refrigerator in the smaller space

dimension than figured, it may cause temperature

rise in the unit, loud noise and failure.

• The space between the rear of the refrigerator and

the wall should be 60mm or more, and less than

75mm.

If the space is wider than 75mm, you may get

injured by touching compressor and its peripheral

parts which are extremely hot during the operation.

Overall space required in use

Use the two front the adjustable feet to place the

refrigerator flatly and firmly on the floor.

When right and left doors are not properly aligned,

adjust using the adjustable feet.

When the left door is

raised.

Lower the foot

at right side.

(Until the adjustable foot on the

other side is slightly off-ground.)

90mm

or more

60mm

or more

1500 mm

Adjustable foot

When the right door is

raised.

Lower the foot

at left side.

Remove the 4 screws of the lower part of the cabinet

and use these screws to set the foot cover. (The foot

cover is packed inside the refrigerator compartment.)

Screw

(4 screws)

Note

• Place your refrigerator to access the plug.

• Keep your refrigerator out of direct sunlight and do not

place next to heat generating appliance.

• Do not place your refrigerator directly on the ground.

Insert suitable stand such as wooden board under the

refrigerator.

• When you insert the power plug with the door opened,

door alarm sounds but it is not abnormal. This sound

stops after closing the door.

Before using your refrigerator

Clean the inside parts with a cloth soaked in warm

water.

If soapy water is used, wipe it off thoroughly with water.

Free standing type

Screw

Foot cover