Crestron CLW-SLVD1 Kullanıcı Kılavuzu - Sayfa 8
Anahtar Crestron CLW-SLVD1 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Crestron CLW-SLVD1 13 sayfaları. Crestron clw-dim1 wall box dimmer: user guide
Sayfayı YazdırAppendix: Wiring Diagrams
Following are wiring diagrams for circuits that may be found when installing a dimmer:
Stand-Alone Installations
Figure 1: Wiring a CLW-DIM(S)1
•
Since a -DIMS1 is installed without a slave, the blue lead of the -DIMS1 must be capped.
If a neutral is not present in the wallbox, the wiring shown in the following diagram can be used.
Figure 2: Alternative Wiring of -DIM1 and -DIMS1 Where Neutral is Not Present (Load-Fed Switch Loop)
In the above configuration:
•
The white wire from the -DIMS1 to the load is coded HOT.
•
Since a -DIMS1 is installed without a slave, the blue lead of the -DIMS1 must be capped.
•
The minimum load requirement is 100W.
•
Bulb noise may be present even when the load is off.
•
Circuits with small magnetic low-voltage loads may not work.
8 • Stand Alone Wall Box Dimmer: CLW-DIM1, DIMS1, & SLVD
CLW-DIM1, DIMS1, & SLVD1(W/A/B)
Installation Guide – DOC. 6250A