Sharp Notevision 7 Hızlı Referans
Projektör Sharp Notevision 7 için çevrimiçi göz atın veya pdf Hızlı Referans indirin. Sharp Notevision 7 2 sayfaları. Digital multimedia projector
Sayfayı YazdırQuick Reference for Notevision 7
A. Connecting the Power Cord
Plug the supplied power cord into the AC socket on the back of the
projector.
B. Connecting to a Computer Using the
Standard 15-pin (VGA) Input
1 Connect one end of the supplied computer cable to the INPUT
1 port on the projector.
2 Connect the other end to the Monitor output port on the
computer. Secure the connectors by tightening the thumb
screws.
3 To use the built-in audio system, connect one end of the
supplied computer audio cable to the AUDIO INPUT terminal
on the projector.
Connect the other end to the Audio output terminal on the
computer.
C. Connecting to a Computer Using the
Direct Digital Input (PanelLink™)
1 Connect one end of the digital cable to the INPUT 2 port on the
projector.
2 Connect the other end to the corresponding terminal on a
computer.
3 To use the built-in audio system, connect one end of the
supplied computer audio cable to AUDIO INPUT terminal on
the projector.
Connect the other end to the Audio output terminal on the
computer.
Digital cable (sold separately)
To digital output terminal
Computer audio cable (3.5 mm
stereo minijack cable)
To audio output terminal
XG-NV7XU/QR (E)
1
4 Press POWER ON.
5 Turn on the computer.
6 Press AUTO SYNC to adjust the image.
D. Connecting the Remote Mouse Receiver
IBM or IBM compatible PC
1 Connect one end of the supplied mouse control cable to the
corresponding terminal on the PC.
2 Connect the other end to the remote mouse receiver.
Macintosh
1 Connect the mouse control serial cable to the remote mouse
receiver.
2 Connect the mouse control cable for Mac to the Mac ADB
port on the Mac.
3 Connect the other end of the mouse control cable for Mac to
the mouse control serial cable.
• Make sure that your computer is turned off while making any mouse control
cable connections.
• When using the wireless mouse with an IBM or IBM compatible PC, you
can use either a PS/2 or serial cable connection. (See diagram below.)
• Use the supplied mouse control cable for Mac when using the remote
mouse receiver with a Macintosh computer.
Computer
Digital Multimedia Projector
POWER ON
button
AUTO SYNC
button
Remote mouse receiver
Use this terminal to connect the
supplied mouse control cable
to the remote mouse receiver.
Mouse control cable for IBM PS/2
Mouse control
Mouse control
serial cable
cable for Mac
99.11.8, 2:07 PM