Sharp PG-M10SU Servis Kılavuzu - Sayfa 17

Projektör Sharp PG-M10SU için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Sharp PG-M10SU 31 sayfaları. Sharp digital multimedia projector pg-m10x, pg-m10s operation manual
Ayrıca Sharp PG-M10SU için: Kullanım Kılavuzu (49 sayfalar)

Sayfayı Yazdır

OPTICAL ADJUSTMENT AND MEASURING

1.Adjustment of color wheel sensor

Adjustment needed

1. When the color wheel unit has been replaced

2. When the color wheel sensor has been replaced

3. When the optical drive unit has been replaced (if a deviation from normal setting is found)

4. When the F/E PWB has been replaced (if a deviation from normal setting is found)

Tools required

1. Personal computer (run on Windows 95/98)

2. RGB cable

3. Dedicated application program (white.exe program commonly used for both models UP and U2)

4. Wrench (5 mm)

5. Projection screen (normally white)

Note: During the adjustment, be careful not to touch the lamp and other hot components.

Procedure

1. Adjustment should be done with the top cover and

the front panel removed.

2. Connect the projector to the PC (RGB mode).

3. Start up the dedicated application program

(white.exe) on the PC.

4. Press the "6" key on the keyboard. After the pattern

shown in Fig. 1 at right has appeared, press the

"R" key to get the red image displayed for checking.

Check the other colors as well (*1).

5. When part of the image does not appear in red,

loosen the wheel screw shown in Fig. 2 below and

slide the wheel sensor up or down. Fix the wheel

sensor again at the position where the color

deviation disappears.

6. Finally press the "Q" key on the keyboard to finish

the program.

1:The basic black and white patterns are registered in the numeric keys 0 thru 9 on the keyboard. The colors can be

changed to any of White(W), Black(K), Red(R), Green(G), Blue(B), Magenta(M) and Cyanic(C).

Wheel Sensor

Wheel Screw

PG-M10SU/SE

PG-M10XU/XE

Fig.1

Fig.2