Sharp XG-PH50X - XGA DLP Projector Hızlı Başlangıç Referans Sayfası - Sayfa 4

Projektör Sharp XG-PH50X - XGA DLP Projector için çevrimiçi göz atın veya pdf Hızlı Başlangıç Referans Sayfası indirin. Sharp XG-PH50X - XGA DLP Projector 6 sayfaları. Xga native resolution system integration/large venue projector
Ayrıca Sharp XG-PH50X - XGA DLP Projector için: Kurulum Kılavuzu (2 sayfalar), Kullanım Kılavuzu (20 sayfalar), Kurulum Talimatları Kılavuzu (13 sayfalar), Teknik Özellikler (2 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar)

Sayfayı Yazdır
Sharp XG-PH50X - XGA DLP Projector Hızlı Başlangıç Referans Sayfası
SmartPanel Projector Driver Application Note
II. CONTROL WIRING
PROJECTOR CONTROL
RS232
5 4 3 2 1
5 4 3 2 1
Female DB9
Jumper
9 8 7 6
8 to 7
RS-232 to
Wired Remote to
RS-232C
© 2005 SP Controls Inc. 601 Minnesota Suite 115 San Francisco, CA 94107
This section specifies how RS-232 and Wired Remote
should be wired to the Sharp projector.
A. RS-232 should be connected to the Sharp control port
IR/SERIAL
labeled RS-232C. Connection should be as follows:
1. Wire the Panel to a female DB9 as follows:
2. Connect this female DB9 to the projector port labeled
B. The Wired Remote should be connected to the Sharp
1/8" Mini
Female
1. Wire the Panel to a female 1/8" Mini as shown; wire
2. Attach to the projector port labeled Wired Remote
3. Alternately, replace the male to male cable with the
NOTE: when the Panel is wired to the projector Wired
Remote port, the projector remote control will no longer
function.
ATTENTION: SP Controls strongly recommends wiring
IR in addition to wiring RS-232 in case the Panel must be
configured for IR-only control in the future. See Section V.
Special Control Note below for more information.
Wired Remote
RX to 2
TX to 3
GND to 5
RS-232C.
port labeled Wired Remote.
Connection should be as follows:
IR/SER to tip and GND to ring. Direct wiring to male
1/8" is not recommended as it makes removal of the
Panel for service more difficult.
using a male 1/8" mini to male 1/8" mini (not included).
included the IR Emitter and attach it to one of the IR
windows on the projector. The emitter glows red when
IR is emitted so wiring can be verified.
Sharp XG-PH50X