Accutire MS-5530 Kullanıcı El Kitabı - Sayfa 2

Hava Kompresörü Accutire MS-5530 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Accutire MS-5530 4 sayfaları. Dc 12 volt air compressor/tire inflator

Sayfayı Yazdır

READ CAREFULLY

Unless directions are followed, physical injury or property damage may result.

When using the compressor, never leave it unattended.

Power required: 12 volts 10 amps. D.C.

This compressor is designed for occasional use only. Operation over an

extended period of time will overheat the unit and damage the compressor.

A sluggish operation of the compressor or if the exposed metal fittings

get too warm to the touch should indicate to you that the unit has been

operating too long and is overheating. When this occurs stop the unit

immediately, and let it cool for approximately 30 minutes before resuming

operation.

You may use a 12 volt battery charger to power this compressor, but it

must be rated at 10 amps or more to avoid damage to the compressor

and for the charger.

Do not use air inflator on high pressure tires such as those used on large

trucks.

TO INFLATE TIRES

Place connector on input valve stem (Fig.1) and push down. Close thumb

latch connector (Fig.2). Caution: Make sure the connector always touches

the core of tire valve stem.

Fig. 1

Plug power cord into cigarette lighter receptacle.(Fig.3)

Then set compressor on/off switch to "on" position.

When proper pressure is reached, set on/off switch to "off" position, unplug

power cord and remove connector.

FOR INFLATABLES

Select the suitable adapter and insert it into the connector. (Fig. 4) Close

thumb latch.

Fig. 2

Fig. 3