Shimano CLARIS Series Bayi El Kitabı - Sayfa 21
Bisiklet Aksesuarları Shimano CLARIS Series için çevrimiçi göz atın veya pdf Bayi El Kitabı indirin. Shimano CLARIS Series 48 sayfaları. Shifting lever
Sayfayı Yazdır
MAINTENANCE
Assembling the bracket body and lever body
Assembling the bracket body and lever body
1
2
(A)
3
(z)
(B)
4
Insert the lever into the bracket.
Insert the end of the return spring into
the notch.
Align the axle holes, set the Shimano
(A)
original E-ring removal tool [1] in the
position shown in the illustration, and
then press-fit the lever axle.
(z)
Remove the Shimano original E-ring
removal tool [1], and then use the
Shimano original E-ring removal tool [2]
to install the E-ring.
(A)
Do not press-fit the lever axle
from this direction.
Otherwise, it may damage the
bracket body.
21
(A)
Return spring
(A)
E-ring groove
(B)
Shimano original E-ring removal
tool [1]
TECH TIPS
•
The correct direction for the lever axle is
for the E-ring groove to face up.
•
Check that the surface of the bracket body
is flat so the E-ring of the lever axle can fit
into the groove properly.
(A)
Shimano original E-ring removal
tool [2]
NOTE
Do not use the removed E-ring again.
Be sure to use a new E-ring.