Shimano CN-HG40 Manuel - Sayfa 3

Bisiklet Aksesuarları Shimano CN-HG40 için çevrimiçi göz atın veya pdf Manuel indirin. Shimano CN-HG40 5 sayfaları. Rear drive system

Sayfayı Yazdır

Installation of the rear derailleur

When installing, be careful that deformation is not caused by the B-tension

adjustment screw coming into contact with the dropout tab.

5 mm Allen key

Installation of the sprockets

For each sprocket, the

surface that has the group

mark should face outward

and be positioned so that

the triangle (U) mark on

each sprocket and the A

part (where the groove

width is wide) of the

freewheel body are aligned.

U mark

The groove is

wide at one

place only.

The 6 sprockets are secured by

means of rivets.

Chain length

Add 2 links (with the chain on both the largest

sprocket and the largest chainring)

Mounting the shifting lever

Bracket spindle tightening torque:

8 - 10 N·m {70 - 86 in. lbs.}

B-tension adjustment screw

Dropout tab

For installation of the HG sprockets, use the

special tool (TL-LR15) to tighten the lock ring.

Tightening torque:

30 - 50 N·m {261 - 434 in. lbs.}

To replace the HG sprockets, use the special

tool (TL-LR15) and TL-SR21 to remove the

lock ring.

Disassembly

Largest chainring

Chain

Use a handlebar grip with a maximum

outer diameter of 32 mm.

Allen key tightening torque:

6 - 8 N·m {53 - 69 in. lbs.}

5 mm Allen key

Lock ring

Tool

TL-LR15

(TL-SR21)

Lock ring

Largest chainring