Shimano SORA FC-R3000 Bayi El Kitabı - Sayfa 4

Bisiklet Aksesuarları Shimano SORA FC-R3000 için çevrimiçi göz atın veya pdf Bayi El Kitabı indirin. Shimano SORA FC-R3000 20 sayfaları. Crankset

Sayfayı Yazdır

TO ENSURE SAFETY

• Be sure to follow the instructions provided in the manuals when installing the product.

Only use SHIMANO genuine parts. If a component or replacement part is incorrectly assembled or adjusted, it can lead to component failure and cause

the rider to lose control and crash.

•

Wear approved eye protection while performing maintenance tasks such as replacing components.

Be sure to also inform users of the following:

• Never use alkali- or acid-based solvents such as rust cleaners. If those solvents are used the chain might break and cause serious injury.

• Clean the chain with an appropriate chain cleaner regularly. Intervals between maintenance depend on the use and riding circumstances.

• Check that there are no cracks in the crank arms before riding the bicycle. If there are any cracks, the crank arm may break and you may fall off the

bicycle.

• Be careful not to let the hemming of your clothes get caught in the chain while riding. Otherwise you may fall off the bicycle.

• Check the chain for any damage (deformation or crack), skipping, or other abnormalities such as unintended gear shifting. If any problems are found,

consult a dealer or an agency. The chain may break, and you may fall.

For Installation to the Bicycle, and Maintenance:

• Install the inner cover correctly. If it is not installed correctly, the axle may rust and become damaged, and the bicycle may fall over and serious injury

may occur as a result.

• The two left crank arm screws should be tightened alternately in stages rather than each fully tightened at once. Use a torque wrench to check that

the tightening torques are within the range of 12 - 14 N·m. Furthermore, after riding approximately 100 km (60 miles), use a torque wrench to

re-check the tightening torques. It is also important to periodically check the tightening torques. If the tightening torques are too weak or if the

mounting screws are not tightened alternately in stages, the left crank arm may come off and the bicycle may fall over, and serious injury may occur as

a result.

Be sure to also inform users of the following:

• Be careful not to touch the teeth of chainrings. There is a danger of injury.

Be sure to also inform users of the following:

• Check that there is no excess play or looseness in any fastening sections before riding the bicycle. Also, be sure to retighten the crank arm and pedals

at periodic intervals.

• Be sure to keep turning the crank arm during the shift lever operation.

WARNING

CAUTION

NOTICE