Shimano STEPS E6000 Kullanıcı Kılavuzu - Sayfa 15
Bisiklet Shimano STEPS E6000 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Shimano STEPS E6000 46 sayfaları. Shimano steps e6000 battery and charger
Sayfayı Yazdır
3.2
Adjusting the saddle height
3.2.1 Determining the correct saddle height
1. Sit on the pedelec and at the same time lean against a wall.
2. Turn the foot pedal on the opposite side to the wall to its lowest point.
3. Place your heel on the pedal. Your leg should be fully extended.
4. If your leg is not fully extended when your heel is
on the pedal, raise the saddle. Lower the saddle
if you cannot reach the pedal. The following
sections explain how to adjust the saddle height
on your bike. The seatpost can be fastened using
the saddle clamp bolt
3.2.2 Adjusting the
saddle height: Saddle clamp bolt(s)* Page EN-15
3.2.3 Adjusting the
quick-release skewer
saddle height: Quick-release skewer* Page
WARNING
The seatpost is marked to indicate how far you
may pull it out from the frame. Never pull the
seatpost further out than the marking. This could
cause it to bend or break, and cause you to fall.
Seatpost marking
*dependent on model
or
For 3. Extend leg
EN-16.
3.2.2 Adjusting the saddle height: Saddle clamp bolt(s)*
1. Undo the saddle clamp bolt(s) by turning
it/them anticlockwise with an Allen key.
2. Move the seatpost into the right position.
3. Tighten the saddle clamp bolt(s) again
by turning it/them clockwise
Torque settings Page
EN-46.
4. Test the tightness of the saddle by trying
to move it.
Original User Guide | Pedelec Shimano Steps E6000 Version 1
8.
For 1. Loosen the saddle clamp bolt(s)
For 3. Tighten the saddle clamp bolt(s)
EN-15