Shimano PD-GR500 Bayi El Kitabı - Sayfa 16
Müzik Pedalı Shimano PD-GR500 için çevrimiçi göz atın veya pdf Bayi El Kitabı indirin. Shimano PD-GR500 19 sayfaları. Flat pedal
Sayfayı Yazdır
MAINTENANCE
Axle unit
With the cone locked, tighten the lock nut (7 mm).
PD-M8040
3
PD-M828
Remove old grease and apply an appropriate amount of new grease to the bottom of the
4
pedal body.
• Apply grease to the extent that it does not flow out when the axle is set into the pedal
(about 1.5 g).
Insert the axle unit into the pedal, then tighten the lock bush.
5
(A)
(B)
(z)
(A)
(B)
(z)
(C)
(E)
(D)
(y)
(C)
(D)
16
(y)
7 mm spanner
(z)
Crank side
(A)
Lock bush
(B)
Body cup
(C)
Cone
(D)
Lock nut
(E)
TL-PD63/33
Lock nut tightening torque
(PD-M8040)
5 - 7 N·m
Lock nut tightening torque
(PD-M828)
5 - 7 N·m
NOTICE
•
Use a TL-PD63 or TL-PD33 for PD-M8040
and use 7 mm and 8 mm spanners for
PD-M828.
•
Both the cone and lock nut are threaded
left-hand for the right pedal and
right-hand for the left pedal.
•
Adjust the cone so as to achieve a smooth
rotation without looseness when the axle
unit is set into the pedal.
•
The rotating parts are fastened when the
axle unit is set into the pedal. Adjust them
slightly loose before setup.
•
When assembling the body cup, please
note the direction of the parts.
Tightening torque
10 - 12 N·m