Crestron CNRFHT-30A Kullanım Kılavuzu - Sayfa 14
Verici Crestron CNRFHT-30A için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Crestron CNRFHT-30A 16 sayfaları. Crestron cnrfht-15a handheld rf wireless transmitter: operations guide
Ayrıca Crestron CNRFHT-30A için: Kullanım Kılavuzu (20 sayfalar)
Sayfayı Yazdır
CRESTRON CNRFHT-15/30 & CNIRHT-15/30
TEST/TROUBLESHOOTING:
Table 4 provides corrective action for possible trouble situations. If further assistance is required, please contact a
CRESTRON technical support representative.
TROUBLE
LED on unit does not
illuminate.
Intermittent response during
transmission.
No response from CRESNET II
system.
R E M O T E
C O N T R O L
S Y S T E M S
Table 4. Troubleshooting Guide
POSSIBLE CAUSE(S)
No battery in unit or battery is dead.
Unit is in sleep mode.
Refer to causes when LED does not illuminate.
CNRFHT is not tuned to CNRFGW.
Receiver antenna not extended to optimum length. Extend receiver antenna to nine or 10 inches.
Receiver is blocked or moved.
CNRFGW is in contact with metal.
Refer to causes when LED does not illuminate and
intermittent response during transmission occurs.
NET ID of receiver is incorrectly set.
RF ID or IR ID is incorrectly set.
Program does not match hardware.
Receiver is unplugged (no power).
Two or more receivers are too close together.
Wrong transmitter in use.
Hand-Held Wireless Transmitters
CORRECTIVE ACTION
Install new battery.
Depress and hold any button until unit
transmits.
Refer to corrective action when LED does not
illuminate.
Refer to Installation/Setup for tuning
instructions.
For IR unit, verify direct line-of-sight. For RF
unit, verify that heavy metal is not in vicinity
of transmission.
Verify that heavy metal is not in vicinity of
transmission.
Refer to corrective action when LED does not
illuminate and intermittent response during
transmission occurs.
Enter Performance Viewport in the CRESNET
Workshop. Depress the F4 key to poll the
network. Verify that the NET ID for the
receiver is properly set to match the SIMPL
program.
NOTE:
After changing the CNRFGW identity code,
disconnect and reconnect the network
connector.
Verify that the RF ID or IR ID for the
transmitter is properly set to match the
SIMPL program.
Verify correct program is loaded in system via
Performance Viewport Workshop.
Verify power to the receiver.
Verify that multiple receivers are properly
spaced (>50 feet) from each other.
If multiple transmitters are accessible, verify
proper unit is used.
10
DOC. 8054C