Digital Barriers EdgeVis HD-IP200 Donanım Kurulum Kılavuzu - Sayfa 2
Medya Dönüştürücü Digital Barriers EdgeVis HD-IP200 için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Digital Barriers EdgeVis HD-IP200 13 sayfaları.
Sayfayı YazdırEDGEVIS HD-IP200 HARDWARE INSTALLATION
Introduction
Before proceeding with the installation and setup of your HD-IP200 unit, please ensure that you check the package
contents listed below, refer to the installation notes on the next page and consult the Quick Start Guide that was
supplied with your unit for step-by-step instructions on preparing hardware and software components.
To operate this device you will need to set up, or have access to, the following architecture:
HD-IP200
To proceed you must have access to an EdgeVis Server, with an account created for the encoder to use. If you do not
have an EdgeVis Server available refer to EdgeVis Server Quick Start Guide which will walk through the steps
required to install the server and create the necessary accounts required to proceed.
What is in the box?
EdgeVis encoder
Accessories
Printed materials
How do I configure the HD-IP200 unit?
After the introduction, there are three sections in this document that help you to configure your HD-IP200 unit:
Section 1
Section 2
Section 3
Appendix A
ISSUED: 17 MARCH 2022
sends video to
EdgeVis Server
EdgeVis HD-IP200
AC/DC 12V power supply, mains power lead, USB Wi-Fi dongle, two cellular
antennae, assorted mounting accessories
Quick Start Guide
Basic operations of the unit
Powering the unit and connecting devices or drives to the HD-IP200
Configuring communications on the HD-IP200
Connecting to wired, Wi-Fi and cellular network
Next steps...
With the HD-IP200 unpacked and wired, what are the steps required to set up the encoder?
Troubleshooting and frequently asked questions
Potential hardware issues that may be encountered with an HD-IP200
sends video to
EdgeVis Clients
PAGE 2