Digital Barriers BW600 Kullanıcı Kılavuzu - Sayfa 5

Dijital Kamera Digital Barriers BW600 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Digital Barriers BW600 10 sayfaları. Body worn cameras

Sayfayı Yazdır

EDGEVIS BODY WORN CAMERAS

3) Insert a nano-SIM card into the SIM slot. Check that the notch on the SIM card aligns with the notch on the

bottom left of the slot.

4) Make sure that the SIM card fits within the slot then close the tray. Lock the tray by sliding it to the left. Do

not force the tray. If it does not slide easily then open the tray again and check that the SIM card is sitting

correctly.

5) Once the tray has been closed and locked, continue the instructions in the Battery Replacement section to

reinstall the battery and the front case panel.

Battery Replacement

The battery in the BW600 is replaceable. This may be necessary after the camera has been in continuous use for more

than a year. The standard battery is rated for 500 charge-discharge cycles.

Power off the BW600.

2) Turn the camera so the LCD screen is facing upwards.

3) Remove the 8 rubber bungs covering the screw holes (tweezers or a SIM card removal pin work well).

4) Unscrew the 8 screws using a T5 Torx screwdriver. Take care while doing so to ensure screws are not lost if

they fall out.

5) Once all screws have been loosened carefully pull on the front case panel to remove it. The panel is tightly

fitted. The recommendation is to work around the sides then the corners of the front case to release it. Once

released the front case panel can be set aside. If the case panel does not come off easily then check that there

are no screws still holding the front panel in place. The front case panel can be broken if force is applied while

screws are still holding it in place.

6) The battery compartment will be visible beneath the front case panel. The battery can be removed by lifting it

from each side.

When fitting a new battery check that the battery terminals are clean and do not have any protective covering

in place. Align the battery terminals with the terminals in the BW600 battery compartment and lightly push

down on the battery until it slots into place.

8) To replace the front case panel, first check that the rubber seal around the inner side of the front panel is

intact and held in place. Align the front case panel with the BW600 and carefully press down on each corner

until a click is heard.

9) Replace and tighten all 8 screws. Do not overtighten the screws. Screws should be hand tight (maximum

torque 5nm).

10) Replace the 8 rubber bungs in the screw holes.

Mounting the camera

The BW600 is supplied with two mounting options:

ISSUED: 2 FEBRUARY 2021

PAGE 5