Digital Barriers EDGEVIS VIDEO ROUTER 4 Donanım Kurulum Kılavuzu - Sayfa 7
Ağ Yönlendiricisi Digital Barriers EDGEVIS VIDEO ROUTER 4 için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Digital Barriers EDGEVIS VIDEO ROUTER 4 16 sayfaları.
Sayfayı Yazdır
EDGEVIS VIDEO ROUTER HARDWARE INSTALLATION
Updating the software on the unit
Once notified of a new software release by Digital Barriers, updates are available for download from the EdgeVis
support site (see below for link) for installation onto the device.
There are two ways to update the firmware – locally using a USB Pen, or remotely using EdgeVis Server.
•
To update remotely, upload the new firmware to the Firmware page within the EdgeVis Server web interface
and then, from the Encoder's status and diagnostics page, select Upgrade Firmware from the menu on the
right-hand side.
•
To update locally, copy the update onto a USB flash drive and insert into a USB port on the front of the unit.
The flash drive can be inserted into a running unit or before the unit is powered up. The update procedure will
commence silently when the USB pen is detected, wait 30s to allow the encoder to find and install the
firmware update. After the firmware is installed it is safe to remove the pen and the unit will automatically
reboot.
WARNING: Performing a firmware update or otherwise accessing a unit after it has been deployed may require all
of the equipment and precautions necessary to perform an installation.
To access or register for the Digital Barriers Support Site, visit
Mounting the unit using the universal bracket
The included bracket can be used to mount the unit. The following diagram illustrates how the bracket should be
mounted first (in this example using VESA mounts on a monitor), the mounting screws attached to the unit, then the
unit slid down onto the mount.
ISSUED: 29 NOVEMBER 2022
tvi-support.digitalbarriers.com
PAGE 7