Crestron DM-RMC-4KZ-100-C Hızlı Başlangıç - Sayfa 4

Kontrol Sistemleri Crestron DM-RMC-4KZ-100-C için çevrimiçi göz atın veya pdf Hızlı Başlangıç indirin. Crestron DM-RMC-4KZ-100-C 5 sayfaları. Digitalmedia 8g+® 4k604:4:4 hdr receiver and room controller

Sayfayı Yazdır
Crestron DM-RMC-4KZ-100-C Hızlı Başlangıç
DM-RMC-4KZ-100-C
DigitalMedia 8G+® 4K60 4:4:4 HDR Receiver and Room Controller
Refer to the following table for DM IN wiring information.
DM IN Wiring
Pin Number
1
2
3
4
5
6
7
8

Upgrade the Firmware

Before using the device, upgrade the firmware. The latest firmware can be
downloaded from the
DM-RMC-4KZ-100-C
Crestron website (www.crestron.com).
Wire Color
Orange/White
Orange
Green/White
Blue
Blue/White
Green
Brown/White
Brown
product page on the

Determine the IP Address

The physical configuration of the DM-RMC-4KZ-100-C within a
DigitalMedia 8G+ system determines how the IP address of the receiver
is set:
If the DM-RMC-4KZ-100-C is connected to a DigitalMedia switcher,
l
the IP address is configured by the switcher automatically. You do not
need to set the IP address.
If the DM-RMC-4KZ-100-C is connected directly to a DigitalMedia 8G+
l
transmitter (commonly referred to as a standalone configuration in
which no DigitalMedia switcher is used), the IP address of the receiver
is assigned using DHCP (Dynamic Host Configuration Protocol) by
default. If you wish to assign a static IP address, do either of the
following:
To assign the default static IP address of the receiver, hold down
o
the SETUP button while the unit boots up. The default static IP
address, which is 192.168.1.250, overwrites the current setting.
To manually set a static IP address other than the default address,
o
use the Crestron Toolbox™ software.
Quick Start
4