Digital Barriers EDGEVIS HD-IP250 Kurulum Kılavuzu - Sayfa 13
DVR Digital Barriers EDGEVIS HD-IP250 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Digital Barriers EDGEVIS HD-IP250 14 sayfaları.
Sayfayı YazdırEDGEVIS HD-IP250 HARDWARE INSTALLATION
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
FCC Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
To meet the FCC's RF exposure rules and regulations:
•
The use of a non-shielded interface cable with the EdgeVis HD-IP250 Encoder device is prohibited
•
The power cord must be 3m (10 feet) or less in length and a ferrite should be fitted within 5cm (2 inches) of the equipment
•
The antenna(s) used with the EdgeVis HD-IP250 unit must be installed to provide a separation distance of at least 20cm (8 inches) from all persons
and must not be co-located or operating in conjunction with any other antenna or transmitter
•
The antenna(s) used with the EdgeVis HD-IP250 unit must not exceed 3dBi
The EdgeVis HD-IP250 unit shall only be used for fixed and mobile applications.
CE COMPLIANCE STATEMENT
The HD- IP250 Encoder complies with the following European Union Directives:
•
EN55022:2010 – Limits and Methods of Measurement of Radio Interference Characteristics of Information Technology Equipment
•
EN55024:2010 – Information Technology Equipment – Immunity characteristics – Limits and methods of measurements
The use of this product may be dangerous and has to be avoided in the following areas:
•
Where it can interfere with other electronic devices in environments such as hospitals, airports, aircraft, etc.
•
Where there is risk of explosion such as gasoline stations, oil refineries, etc.
The user must ensure that:
•
The HD- IP250 unit shall only be used for fixed and mobile applications
It is responsibility of the user to enforce the country regulations and specific environment regulations.
ISSUED: 10 NOVEMBER 2020
PAGE 7