Crestron Electronics TST-1080 Kurulum Kılavuzu - Sayfa 5

Dokunmatik panel Crestron Electronics TST-1080 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Crestron Electronics TST-1080 14 sayfaları. 10.1 in. wireless touch screen

Sayfayı Yazdır

• For postconstruction applications where mounting hardware will be installed in an existing framed

wall or similar flat surface using a mud ring, refer to

• For postconstruction applications where mounting hardware will be installed in an existing framed

wall or similar flat surface using a trim ring, refer to

Install the TST-1080-DSW

The following procedure assumes that the a TST-1080-DSW mounting accessory has been installed

completely as described in

hardware, it is also assumed that drywall is in place and a cutout for the TST-1080-DSW has been made.

To install the TST-1080-DSW wall dock:

1. Route the wiring for the TST-1080-DSW power connection through the rear of the mounting

hardware.

NOTE: The maximum wire size for the power connection is 18 AWG.

2. While holding the TST-1080-DSW, connect the flying leads from the wiring to the 2-pin power

connector (24 G) on the rear of the TST-1080-DSW.

3. Attach the TST-1080-DSW to the mounting hardware using the four 6-32 x 1-1/2 in. screws.

The following illustration shows the TST-1080-DSW being attached to the TST-902-DSW-BB back

box as an example.

NOTE: The cradle for the touch screen on the TST-1080-DSW should be in the closed position

during installation.

— Doc.

Installation Guide

9338A

Install the Mounting Hardware

TST-902-DSW-WMKM

Installation.

TST-902-DSW-WMKT

Installation.

(on page 4). For preconstruction mounting

Contents •