Digital Dynamics LIONEL TRAINmaster LCRU Kurulum Talimatları Kılavuzu - Sayfa 3

Alıcı Digital Dynamics LIONEL TRAINmaster LCRU için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Digital Dynamics LIONEL TRAINmaster LCRU 18 sayfaları. Locomotive command receiver unit for single or dual ac motor locomotives

Sayfayı Yazdır

Introduction

Please take the time to read and thoroughly understand the instructions in this manual. While

it is unlikely that any damage may occur to your engine, improper installation of the Lionel

LCRU may cause permanent damage to its circuit components.

A minimum amount of soldering skill is required to perform this installation correctly. If you

feel that you do not possess the proper soldering equipment or the expertise, you should refer

installation to your dealer or to Digital Dynamics.

If you think that the wiring of your particular engine is different from what is described in

this manual, do not attempt installation unless you have some experience with AC motor circuits.

Instead, contact Digital Dynamics for assistance.

Installation Instructions

The Lionel LCRU can be installed into almost any Postwar or modern era Lionel locomotive with

little or no difficulty. While these instructions describe specific installation examples, they

should serve as guidelines for installation into any locomotive provided there is sufficient

mechanical clearance to do so. The wiring examples shown here are very similar, if not

identical, to those of other Lionel locomotives not specifically mentioned in this

documentation.

The Lionel LCRU is designed exclusively for AC motor locomotives. It cannot be used with DC

motor locomotives such as those produced by MTH, K-Line, Weaver, or Williams. If you are unsure

which type of motor you have, contact Digital Dynamics for assistance.

Tools Required

Low power soldering iron

Rosin core solder

Small wire cutters

Small long-nosed pliers

Wire strippers

Small flat blade screwdriver

Small Phillips screwdriver

Razor Blade or Exacto Knife

What's Supplied

LCRU circuit board

Plug-in Antenna

Four (4) plug-in hookup wires

Four (4) 1uF non-polarized capacitors

Four (4) solder washers

Plastic Ty-Wraps

Wire Nuts

Three (3) Double Sided Foam Adhesive Tape Strips

One #4 x 1/4" sheet metal screw

* * * Important Note! * * *

LCRU Installation Manual