Digital Electronics PS3650A-T42S-24V Kurulum Kılavuzu - Sayfa 7

Monitör Digital Electronics PS3650A-T42S-24V için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Digital Electronics PS3650A-T42S-24V 17 sayfaları.

Sayfayı Yazdır
Switch
No.
1
Used for the system.
2
Used for the system.
3
Change Reset SW mode.
Sets up an enabled/disabled state
4
for the port execution control
function of hardware reset switch.
5
Used for the system.
Sets up an enabled/disabled state
6
for the front USB port execution
control function.
7
Used for the system.
Cancellation function of pushing
8
two points on the touch panel
9
Used for the system.
Changes COM1's # 9 pin
10
(RI <---> +5V).
Enabled only when RS-232C mode
*1 The PS-A restarts when pressing the switch in the Soft OFF state. Soft OFF means Windows
been shut down and the power is provided only for the electric circuit to boot system. This Soft OFF
State is different from System Standby set by Windows
*2 Setting up an enabled/disabled state for the USB port execution control function is available for only
®
Windows
. Make sure to disable the function of the setting when using another OS.
Factory setting is RS-232C. Only SW No.1 is ON.
Switch
Description
No.
Changes COM1's
1
communication
method.
Changes COM1's
2
communication
method.
Changes COM1's
3
communication
method.
Changes TX data's
4
output mode.
Description
*1
*2
Table 1) System Set Switch 1
ON
RS-232C
RS-422/RS-485
RS-422/RS-485
TX data output is
controlled via the
RTS signal.
ON
OFF
Reserved
Reserved
Reserved
Reserved
Power
Reset SW
button
Disabled
Enabled
*1
Reserved
Reserved
Disabled
Enabled
Reserved
Reserved
Enabled
Disabled
Reserved
Reserved
+5V
RI
Output
®
.
OFF
RS-422/RS-485
RS-232C
RS-232C
TX data output is
NOT controlled via
the RTS signal.
(normally output)
7
Notes
Factory Settings: ON
Factory Settings: OFF
Factory Settings: OFF
Factory Settings: OFF
Factory Settings: OFF
Factory Settings: OFF
Factory Settings: OFF
Factory Settings: OFF
The middle point is not
considered to be touched when
the SW is ON.
It is considered to be touched
when the SW is OFF.
Factory Settings: OFF
Factory Settings: OFF
RS-232C
RS-422
ON
OFF
OFF
ON
OFF
ON
OFF
ON/OFF
®
has
RS-485
OFF
ON
ON
ON/
*1
OFF