Digital Electronics Corporation PL-3600T Series Kurulum Kılavuzu - Sayfa 14

Endüstriyel PC Digital Electronics Corporation PL-3600T Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Digital Electronics Corporation PL-3600T Series 19 sayfaları.

Sayfayı Yazdır

(2) Push the Opening button by a small and flat

screw driver to open the desired pin hole.

(3) Insert each pin terminal into its each

hole. Release the Opening button to

clamp the pin place.

AC power supply cable

Black

White

Green/Yellow

(4) After inserting all three pins, insert the

Power Plug into the Power Connector at

PL. Fix the plug with two minus screws.

• Confirm that all wires are connected

correctly.

• The torque required to tighten these

screws is 0.5 to 0.6 N•m [5-7Lb•In].

• To prevent the possibility of a terminal

short, use a pin terminal that has an

insulating sleeve.

Wiring the DC type power supply cable

• When the FG terminal is connected, be

sure the wire is grounded. Not ground-

ing the PL unit will result in excessive

noise. Use your country's applicable

standard for grounding.

Power Cord Specifications

Use copper conductors only.

Power Cord

0.75 to 2.5mm

Diameter

(18 - 12 AWG)

Conductor Type Simple or Stranded Wire

Conductor

Length

*1 If the Conductor's end (individual) wires are not

twisted correctly, the end wires may either short

against each other, or against an electrode.

Opening button

7mm

[0.28in]

Power Connector (Plug) Specifications

−

Insertion Direction

• Accompanying power supply connector is

CA5-DCCNL-01 of Pro-face or

GMVSTBW2.5-3-STF-7.62 of Phoenix

Contact.

When connecting the power code, use the

following items when performing wiring.

(Items are made by Phoenix Contact.)

Recommended

Driver

Recommended

Pin Terminals

Recommended

Pin Terminal

Crimp Tool

Connecting the PL Power Cord

(1) Confirm that the power is not supplied to

the PL unit.

(2) Loosen three screws in the center of the

Power Connector (plug).

(3) Strip the power cord, twist the conductor's

wire ends, insert them into the pin terminal

and crimp the terminal. Attach the terminal

to the Power Connector.

• Use a flat-blade screwdriver (Size 0.6 x

3.5) to tighten the terminal screws.

The torque required to tighten these

screws is 0.5 to 0.6 N•m [5-7Lb•In.].

24V

Grounding

Terminal

connected

to the PL

chassis

SZF 1-0.6x3.5

(1204517)

AI 0.75-8GY (3200519)

AI 1-8RD (3200030)

AI 1.5-8BK (3200043)

AI 2.5-8BU (3200522)

CRIMPFOX ZA 3

(1201882)