BITS SMART STRIP MCG-8MVR Kullanıcı Kılavuzu - Sayfa 3

Aşırı Gerilim Koruyucu BITS SMART STRIP MCG-8MVR için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. BITS SMART STRIP MCG-8MVR 4 sayfaları. Energy saving surge protector

Sayfayı Yazdır
INSTALLING THE SMART STRIP
Power Switch
This LIGHTED SWITCH is also a 15 amp circuit breaker. It is normally left on. If it's
not lit, turn it on, reset it or try a different outlet.
Ground & Surge Indicator
When this is lit, your equipment is protected. If it's not, it might be:
A bad or unavailable ground, use another outlet.
1.
2.
The surge protection has failed; check http://bitsltd.net/FAQ or call us.
Control Outlet
Plug your TV or computer here. This outlet controls the SWITCHED OUTLETS; if
the device plugged in here is on, they are on. If off or in sleep mode, they are off.
Constant Hot Outlets
Plug your Cable box, satellite receiver, DVR, fax or cable modem here. These
outlets will only turn off with the power switch.
Automatically Switched Outlets
Plug in all of your other accessories here. These will turn on or off with the
device plugged in the CONTROL OUTLET automatically. So when the device
in the control outlet is off or in sleep mode, everything here is electronically
unplugged, saving you energy and eliminating "Phantom Current" draw.
SETTING THE SENSITIVITY ADJUSTMENT
You may need to adjust the Smart Strip's
calibrate using a small screwdriver.
First, plug a CONTROL DEVICE and SWITCHED DEVICE into the proper outlets and
test the Smart Strip
DEVICE turns on and off with the CONTROL DEVICE, you're ready to go!
If the switched outlets do not turn on:
1.
Turn on the device that is plugged into the CONTROL OUTLET.
2.
Turn the dial slowly clockwise until the SWITCHED OUTLETS turn on.
3.
Turn off the device in the control outlet; if the SWITCHED OUTLETS are off,
you're done.
If the switched outlets do not turn off:
1.
Turn off the device that is plugged into the CONTROL OUTLET.
2.
Turn the dial slowly counterclockwise until the SWITCHED OUTLETS turn off.
3.
Turn on the device that is on the CONTROL OUTLET; if the SWITCHED
OUTLETS are on, you're done.
by turning the Control Device on and then off. If the SWITCHED
®
®
sensitivity. Fortunately, it's easy to
®