Siemens simatic ET 200MP Manuel - Sayfa 16

Endüstriyel Ekipmanlar Siemens simatic ET 200MP için çevrimiçi göz atın veya pdf Manuel indirin. Siemens simatic ET 200MP 33 sayfaları. Digital output module dq 16x230vac/2a st relais (6es7522-5hh00-0ab0)
Ayrıca Siemens simatic ET 200MP için: Manuel (40 sayfalar), Manuel (24 sayfalar), Manuel (29 sayfalar), Manuel (47 sayfalar), Manuel (26 sayfalar), Manuel (28 sayfalar), Manuel (50 sayfalar), Manuel (34 sayfalar), Kullanıcı Kılavuzu (44 sayfalar), Manuel (30 sayfalar), Manuel (25 sayfalar), Manuel (42 sayfalar), Manuel (28 sayfalar), Manuel (49 sayfalar), Manuel (36 sayfalar), Manuel (39 sayfalar), Manuel (28 sayfalar), Ekipman Kılavuzu (35 sayfalar), Ekipman Kılavuzu (32 sayfalar), Manuel (29 sayfalar), Manuel (34 sayfalar), Manuel (36 sayfalar), Ekipman Kılavuzu (50 sayfalar), Manuel (45 sayfalar)

Sayfayı Yazdır
Siemens simatic ET 200MP Manuel
Support for selecting hardware components
We recommend you use the TIA Selection Tool for planning your project. The TIA Selection
Tool is available free of charge as a desktop version for download or as a cloud version, refer
to the Internet
selection-tool.html).
3.4

Wiring of the module

Requirement
• The I/O modules are installed on the mounting rail.
• The supply voltage of the station is switched off.
Procedure
1. Plug the two SIMATIC TOP connect connecting cables with the 40-pin IDC connector into
X10 and X11.
Note when plugging:
– ① The nob on the left edge of connector X11
– ② The nob on the right edge of connector X10
2. Guide the SIMATIC TOP connect connecting cables down to the module.
3. Guide a cable tie around the module at the fixing points and connect the SIMATIC TOP
connect cables.
Digital output module DQ 64x24VDC/0.3A BA (6ES7522-1BP00-0AA0)
Equipment Manual, 07/2020, A5E48024569-AA
(https://new.siemens.com/global/en/products/automation/topic-areas/tia/tia-
Figure 3-3
Connect the SIMATIC TOP connect 40-pin connecting cable to the module
Wiring
3.4 Wiring of the module
15