Siemens SINAMICS S120 Manuel - Sayfa 18

Endüstriyel Ekipmanlar Siemens SINAMICS S120 için çevrimiçi göz atın veya pdf Manuel indirin. Siemens SINAMICS S120 43 sayfaları. Applications for cabinet modules, liquid-cooled
Ayrıca Siemens SINAMICS S120 için: Kullanım Kılavuzu (20 sayfalar), Başlarken (32 sayfalar), Manuel (41 sayfalar), Kısa Açıklama (22 sayfalar), Deniz Tahrik Uygulamaları İçin Kabinlere Montaj Talimatı (28 sayfalar), Uygulama Kılavuzu (34 sayfalar), Uygulama Kılavuzu (46 sayfalar), Kullanım Talimatları Kılavuzu (22 sayfalar), Başlarken (32 sayfalar), Kullanım Talimatları Kılavuzu (21 sayfalar), Mühendislik El Kitabı (30 sayfalar), Devreye Alma Kılavuzu (20 sayfalar)

SINAMICS S120 Fail-Safe Drives

The motors rotate in opposite directions.

When button –S8 is pressed, the drives receive a higher setpoint - inde-

pendent of the position of the safety door. For drive 1, n=1000 rpm and for

drive 2, n=666 rpm. When the safety door is open, then an SLS limited

value is violated and the drive involved is stopped using an internal SS2

(Stop C), and for n=0 rpm is brought into SOS. In order to continue to oper-

ate the drive, the alarm, initiated by the internal SS2 (Stop C) as well as the

"Internal Event" message signal in the TM54F must be acknowledged using

the –S4 reset button.

5.2

Summary of the input signals

Digital inputs of the CU320

Digital input CU320

DI0

ON/OFF1 (1 signal, positive signal

DI1

edge) and stopping (0 signal) (switch –

S6)

Acknowledgement of the SINAMICS

DI2

fault messages (1 signal, pushbutton –

S7)

A higher setpoint speed is entered

DI3

(1 signal, pushbutton –S8)

I DT Safety Integrated

–

Both drives are started

The SINAMICS fault messages are

acknowledged at all of the drive

objects

A high setpoint speed is entered; this

is used to violate the SLS limit as

simulation (1 signal)

Page 18/43

Entry ID: 28424136

MC-FE-I-005-V11-EN